曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

_______ SKIN. DO NOT BREATHE THE FUMES FROM THE SOLVENT. PUT ON A PROTECTIVE SPLASH GOGGLE AND GLOVE WHEN YOU USE THE SOLVENT. KEEP THE SOLVENT AWAY FROM SPARKS, FLAME, AND HEAT. THE SOLVENT IS A POISONOUS AND FLAMMABLE MATERIAL WHICH CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (9) Clean the oil screen:
 (a)
Remove the oil screen from the filler port of the oil tank.

 (b)
Clean the oil screen with the solvent.

 (c)
Dry the oil screen with the air.

 TASK 49-91-31-603-014
 3.  Fill the Oil Tank (Fig. 301)
_________________
 A.  Consumable Materials
 (1)
D00068 Aircraft Turbine Engine Oil - MIL-PRF-23699 Type II

 (2)
D00071 Aircraft Turbine Engine Oil - MIL-PRF-7808 Type I

 B.  References
 (1)
AMM 12-13-31/301, APU Oil Tank

 (2)
AMM 49-11-00/201, APU Power Plant

 (3)
AMM 49-91-12/401, Oil Pump Filter

 C.  Access
 (1)  
Location Zones
 101 Control Cabin, LH
 205 Electronic Compartment
 703 APU Compartment

 (2)  
Access Panels
 1201 Electronic Equipment Access Door
 3804 APU Cowl Door
 3876 APU Oil Filler Door

 

 D.  Procedure
 S 433-017
 (1) For an oil change with a new type of oil, do these steps:
 (a) Connect all the oil lines to the oil cooler.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 49-91-31
 ALL  ú ú 01 Page 304 ú Mar 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
(b)  Install a new oil pump filter (AMM 49-91-12/401).
 S 433-019
 (2)  
Install the drain plug with a new packing.

 S 433-020

 (3)  
Install the filler neck to the filler port:

 (a)  
Install the oil screen in the filler port of the oil tank.

 (b)  
Examine the O-ring seals on the filler cap and the filler neck and replace them if they are damaged.

 (c)  
Install the filler neck in the filler port of the oil tank.

 (d)  
Attach the filler neck to the filler port with the bolts,
 washers and nuts.

 

 

 S 613-052
 CAUTION: DO NOT MIX THE TWO TYPES OF OIL (MIL-PRF-7808 TYPE I AND
_______ MIL-PRF-23699 TYPE II) WHEN YOU ADD THE OIL IN THE APU. IT IS PERMITTED TO MIX DIFFERENT BRANDS OF OIL WITH THE SAME TYPE OF OIL WHEN YOU ADD THE OIL IN THE APU. A MIXTURE OF THE TWO TYPES OF OIL IN THE APU CAN CAUSE DAMAGE TO THE APU.
 CAUTION: DO NOT PERMIT THE OIL LEVEL TO INCREASE MORE THAN THE
_______ 'FULL' MARK ON THE DIPSTICK OR SIGHT GLASS. IF THE OIL TANK IS TOO FULL, THE OIL WILL MAKE FOAM AND CAUSE A LOW OIL PRESSURE.
 (4)  
Fill the oil tank with the oil (AMM 12-13-31/301).

 S 433-025

 (5)  
Install the filler cap in the filler neck of the oil tank.

 S 863-055

 (6)  
Set the circuit breaker and the switch:

 (a)  
Remove the DO-NOT-CLOSE tag and close this circuit breaker:
 1) E3-3 Electrical Shelf, APU Control Unit

 (b)  
Remove the DO-NOT-OPERATE tag from the APU master switch on the P5 forward overhead panel.

 

 S 873-026
 (7)  
For an oil change with a new type of oil, do the APU dry motoring to fill the oil pump (AMM 49-11-00/201).

 S 793-027

 (8)  
APUs WITH ALLIEDSIGNAL SB GTCP85-49-7096; Examine the lubrication system for leakage:

 (a)  Start the APU and let it operate for 3-5 minutes
 (AMM 49-11-00/201).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 49-91-31
 ALL  ú ú 02 Page 305 ú Mar 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / GTCP85-129 SERIES /737-300/400/500/ ENGINES/MAINTENANCE MANUAL ////////////////////////
(b)  
During the APU operation, examine the lubrication system for
 leakage.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 AIRBORNE AUXILIARY POWER 2(156)