(b)
If the firing pin is in the fired position (you cannot install the release pin), the generator has fired.
S 902-115
(3) If the generator has fired, do the steps that follow:
(a)
Remove the generator (AMM 35-22-11/401).
(b)
Install a new generator (AMM 35-22-11/401).
S 212-100
CAUTION: IN ADDITION TO THE SAFETY PIN, A SECONDARY SAFETY DEVICE IS
_______ USED FOR THE TRANSPORT OF THE SPARE OXYGEN GENERATOR. THIS SECONDARY SAFETY DEVICE MUST BE REMOVED FROM THE FIRING PIN'S RELEASE PIN HOLE, BEFORE THE RELEASE PIN CAN BE INSTALLED. FAILURE TO DO SO COULD PREVENT THE OXYGEN GENERATOR FROM CORRECTLY ACTIVATING WHEN OXYGEN MASKS DEPLOY.
(4) Remove the secondary safety device, if installed, from the release pin hole in the firing pin.
NOTE: The release pin hole is the larger of the two holes in the
____
generator firing pin.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
35-22-11
ALL ú ú 02 Page 209 ú Jul 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
S 212-142
(5) Inspect the release pin for defects.
(a) Remove and replace the release pin, if it is gauled, bent or corroded.
S 212-101
CAUTION: MAKE SURE THAT THE RELEASE PIN IS INSTALLED IN THE LARGER OF
_______ THE TWO HOLES, AND THAT THE SAFETY PIN IS INSTALLED IN THE SMALLER OF THE TWO HOLES IN THE FIRING PIN. FAILURE TO DO SO COULD PREVENT THE OXYGEN GENERATOR FROM CORRECTLY ACTIVATING WHEN OXYGEN MASKS DEPLOY.
(6) If the release pin is not installed, put the release pin in the larger of the two holes in the generator firing pin.
NOTE: Make sure the safety pin is between the release pin and the
____
firing pin spring case (Fig. 201).
S 442-102
(7)
Carefully pull the safety pin from the firing pin.
S 412-104
(8)
If no other maintenance is necessary, close the service unit as applicable.
(a) For the Passenger Service Unit (PSU), push the PSU panel upward to engage the cam latches.
NOTE: The latches will generally make a "click" sound when
____
they fully engage.
(b) For the Attendant Service Unit (ASU) or Lavatory Service Unit (LSU), do these steps: 1) Repack the oxygen masks (AMM 35-22-31/201). 2) Close the oxygen box door and push on it to engage the door
latch.
NOTE: The latch will generally make a "click" sound when
____
it fully engages.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
35-22-11
ALL ú ú 02 Page 210 ú Mar 12/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
OXYGEN GENERATOR - REMOVAL/INSTALLATION
_______________________________________
1. General_______
A. This procedure gives the instructions for the removal and installation of the Passenger Oxygen System oxygen generators.
B. This procedure gives the instructions for the removal and installation of the oxygen generators in the Attendant and the Lavatory Oxygen System. These systems locate the generator within the mask box. After you install the generator, you must complete the packing procedure for the oxygen masks.
C. Before you remove an oxygen generator, you must install a safety pin to deactivate the generator. When you install a generator, the safety pin must be removed to activate the generator after maintenance. Refer to AMM 35-22-11/201 for oxygen generator deactivation and activation procedures.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 氧氣 OXYGEN(44)
