D.  Access
 (1)  Location Zones 107 Top of Fuselage, Center 209 Bottom of Fuselage, Forward 219 Bottom of Fuselage, Aft (AIRPLANES WITH VHF-3 ANTENNA)
 E.  Procedure
 S 864-001
 (1)  Open the applicable circuit breaker that follows and attach a DO-NOT-CLOSE tag:
 (a)  
P6-1 Circuit Breaker Panel
 1) VHF-2

 (b)  
P18-2 Circuit Breaker Panel
 1) VHF-1
 2) VHF-3 (if installed)

 S 024-002
 (2)  Do these steps to remove the VHF communication antenna:
 (a)  
Remove the 10 screws that attach the antenna to the airplane.

 (b)  
While you hold the antenna, break the seal with the sealant removal tool.

 CAUTION:_______BE CAREFUL WITH THE SEALANT REMOVAL TOOL. YOU CAN CAUSE DAMAGE TO THE AIRPLANE SKIN OR THE ELECTRICAL CABLE.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 23-21-11
 ALL  ú ú 01 Page 401 ú Nov 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL

MOUNTING SCREW (10 LOCATIONS)
VHF ANTENNAS
VHF Antenna Installation
Figure 401

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 23-21-11
 ALL  ú ú 01 Page 402 ú Jul 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A13039
A
737-300/400/500MAINTENANCE MANUAL
 (c)  
Pull the antenna away from the airplane until you have access to the connector on the coaxial cable.

 (d)  
Disconnect the coaxial cable and remove the antenna.

 NOTE: For the top antenna, the cable can fall through the
____ hole. Make sure you attach the cable to something to prevent this.
 S 114-003
 (3)  Clean the airplane surface (AMM 20-10-34/701):
 (a)  
Remove the used sealant from the airplane surface.

 (b)  
Rub the airplane surface with the solvent and a clean rag.

 TASK 23-21-11-404-019
 3. VHF Communication Antenna Installation
_______________________________________
 A. Consumable Materials
 (1)  
A00247 Sealant - chromate, Type BMS 5-95, Class B

 (2)  
G00009 Corrosion Inhibiting Compound BMS3-23

 B. References
 (1)  
SWPM 20-20-00, Standard Wiring Practices Manual

 (2)  
AMM 23-21-00/501, VHF Communication System

 (3)  
AMM 51-31-00/201, Seals and Sealing

 C. Access
 (1)  Location Zones 107 Top of Fuselage, Center 209 Bottom of Fuselage, Forward 219 Bottom of Fuselage, Aft (airplanes with VHF-3 installed)
 D. Prepare to Install the VHF Antenna
 S 864-004
 (1) Make sure the applicable circuit breaker that follows is open:
 (a)  
P6-1 Circuit Breaker Panel
 1) VHF-2

 (b)  
P18-2 Circuit Breaker Panel
 1) VHF-1
 2) VHF-3 (if installed)

 S 164-005
 (2)  
Make sure the mating surfaces of the antenna and the airplane are clean.

 S 624-006

 (3)  
Apply corrosion inhibiting compound BMS3-23 to the mating surface.

 E. Install the VHF Antenna
 S 964-013
 (1) Replace the used O-ring on the antenna if it is necessary.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 23-21-11
 ALL  ú ú 01 Page 403 ú Nov 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 S 414-008
 (2)  
Connect the coaxial cable to the antenna.

 S 424-009

 (3)  
Attach the antenna to the airplane with the 10 screws.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 通訊 COMMUNICATIONS(28)