NOTE: It will be necessary to press together front end of tail cone slightly to facilitate removal.
D.  If new tail cone is to be installed, remove elevator index plates and rudder index plate  (Ref Chapter 27, Elevator Index Plate - R/I and Rudder Index Plate - R/I).
543 
Jun 20/89  BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.  53-53-0 Page 401 

4.  Install Tail Cone
A.  Check that ACC COMP LITS circuit breaker on P18 is open. On airplanes with a tail cone oscillating navigational light, check that OSC NAV LT circuit breaker on P18 is open.
B.  Place tail cone on bulkhead making sure that alignment marks align and install washers and fasteners.
C.  Remove protective plastic shields.
D.  If new tail cone is being installed, install elevator index plates and rudder index plate  (Ref Chapter 27, Elevator Index Plate - R/I and Rudder Index Plate - R/I).
E.  Connect wire bundle at electrical connector located on bulkhead at body station 1156.
5.  Restore Airplane to Normal Configuration
A.  If removed, connect elevator control pushrods or install elevator (Ref 27-31-11 R/I).
B.  Install exhaust duct and aft fairing (Ref Chapter 49, Exhaust Duct - R/I and Aft Fairing - R/I).
C.  Install access panels.
D.  Close circuit breakers.

543 
53-53-0 Page 402  BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.  Jun 20/89