曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 (10) If the NLG makes a loud noise as it closes, replace the UPLOCK ASSY-NLG DOOR (2534GM), (Ref. AMM TASK 32-31-14-000-001) and (Ref. AMM TASK 32-31-14-400-001). 
R R  (11) If the NLG door opens and closes undemanded, do the Operational Check to Ensure Safety Valve Closes at 260 kts (Ref. AMM TASK 32-31-00-710-005).
R  (12) If the operational test at step (11) is unsatisfactory, replace the SAFETY VALVE-L/G SYS ISOLATION (49GA), (Ref. AMM TASK 32-31-17-000-001) and (Ref. AMM TASK 32-31-17-400-001).
 (13) If the fault continues, the NLG is slow to operate or the fault continues after the subsequent flight, replace the ACTG CYL-NLG (2527GM) (Ref. AMM TASK 32-31-22-000-001) and (Ref. AMM TASK 32-31-22-400-001).

 

 TASK 32-31-00-810-866
 MLG (LH) Does Not Uplock
 WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______
 GEAR.

 WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______
 START A TASK ON OR NEAR:

 - THE FLIGHT CONTROLS

 - THE FLIGHT CONTROL SURFACES

 - THE LANDING GEAR AND THE RELATED DOORS

 - COMPONENTS THAT MOVE.

 1. Possible Causes
_______________
R - UPLOCK ASSY-MLG, L (2509GM) R - proximity sensors and targets R - grease contamination of the uplock proximity sensors and targets
 - MLG (LH) lockstay assembly R
 - ACTG CYL-MLG L (2503GM)
 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
R 32-31-00-810-846 L/G Failure of one of the uplock proximity sensors
R 8GA thru 13GA AMM 32-11-00-200-001 Inspection/Check of the Main Gear AMM 32-11-00-220-003 Detailed Dimensional Check of the MLG Lockstay
 Assembly AMM 32-31-00-200-001 Detailed Inspection of Gear Uplock and Door Uplock Units and Pins AMM 32-31-00-720-002 Functional Test of the Normal Extension and
 Retraction of the Landing Gear
 AMM 32-31-46-000-001 Removal of the MLG Actuating Cylinder
 AMM 32-31-46-400-001 Installation of the MLG Actuating Cylinder

R
 3. Fault Confirmation
__________________
 A. Procedure
 (1) Do a check of the post flight report. If there is a SYS DISAGREE ECAM message and related MLG (LH) uplock target-position CFDS message, do the Fault Isolation procedure.
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞32-31-00∞∞∞∞∞∞∞∞∞∞Page A245
 Aug 01/05 CES

 4. Fault Isolation
_______________

 A. Procedure NOTE : The procedure that follows, gives the information necessary to
____ identify mechanical faults related to the MLG (LH).
 (1) Do the inspection/check of the main gear (LH) (Ref. AMM TASK 32-11-00-200-001).
R (2) Do a check of the UPLOCK ASSY-MLG, L (2509GM) proximity sensors and R targets (Ref. TASK 32-31-00-810-846).
R (a) If the indications are not correct during the check, do the R following:
R 1_ Do a check for grease contamination of the uplock proximityR sensors and targets.
R 2_ If there is too much grease in the area, clean off the greaseR and do the check in Para. 4.A. again.
R NOTE : Grease contamination can cause incorrect indications.
____ R
 (3) Do the detailed dimensional check of the MLG (LH) lockstay assembly (Ref. AMM TASK 32-11-00-220-003).
R (4) Do the detailed inspection of the MLG (LH) uplock (Ref. AMM TASK 32-31-00-200-001).
R (5) Correct all faults found.
 (6) Do the functional test of the normal extension and retraction of the landing gear (Ref. AMM TASK 32-31-00-720-002).

 (7) If the fault continues, the MLG (LH) is slow to operate or the fault continues after the subsequent flight, replace the ACTG CYL-MLG L (2503GM) (Ref. AMM TASK 32-31-46-000-001) (Ref. AMM TASK 32-31-46-400-001)

 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞32-31-00∞∞∞∞∞∞∞∞∞∞Page A246
 Aug 01/05 CES

 TASK 32-31-00-810-867

 MLG (RH) Does Not Uplock
 WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______
 GEAR.

 WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______
 START A TASK ON OR NEAR:

 - THE FLIGHT CONTROLS

　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 起落架 LANDING GEAR 1(57)