曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 - replace the AMU (1RN) (Ref. AMM TASK 23-51-34-000-001) and (Ref. AMM TASK 23-51-34-400-001).
 (a) If the fault continues:
 - do a check and repair the wiring from VHF 3 transceiver (1RC3) to AMU (1RN) of the AUDIO SIDETONE OUTPUT signal, from pins AB/15A, 15B to pins AA/3A, 3B) (Ref. ASM 23-51/06).
 B. Do the test given in Para. 3.
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞23-12-00∞∞∞∞∞∞∞∞∞∞Page 228
 May 01/01R CES

 TASK 23-12-00-810-819

 Loss of the BUS 1 Data from the CFDIU to the VHF 1
 1. Possible Causes_______________
 - XCVR-VHF, 1 (1RC1) - wiring
 2. Job Set-up Information______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM AMM AMM ASM  23-12-00-740-001 23-12-33-000-001 23-12-33-400-001 31-32/02 BITE Test of the VHF SystemRemoval of the VHF Transceiver (1RC1, 1RC2, 1RC3)Installation of the VHF Transceiver (1RC1, 1RC2, 1RC3)
 3. Fault Confirmation__________________
 A. Make sure that this(these) circuit breaker(s) is(are) closed:
R  -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU CFDS/CFDIU/SPLY 2TW J18 
R  **ON A/C ALL 
R  Post SB  31-1163 For A/C 155-156,208-209, 
R  121VU CFDS/CFDIU/BACK/UP  8TW  J17 
R  **ON A/C ALL
 B. Do the BITE test of the VHF system (Ref. AMM TASK 23-12-00-740-001).
 NOTE : Do this test for the VHF 1 only.____

 4. Fault Isolation
_______________

 A. If the test gives the maintenance message CFDIU (1TW)/VHF1 (1RC1):
 - replace the XCVR-VHF, 1 (1RC1) (Ref. AMM TASK 23-12-33-000-001) and (Ref. AMM TASK 23-12-33-400-001).
 (1) If the fault continues:
 - do a check and repair the wiring of the BUS 1 OUTPUT signal, (from VHF 1 transceiver (1RC1) pins AB/6A, 6B to the first terminal block)(Ref. ASM 31-32/02).
 B. Do the test given in Para. 3.B.
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞23-12-00∞∞∞∞∞∞∞∞∞∞Page 230
 Feb 01/05R
 CES

 TASK 23-12-00-810-820

 Loss of the BUS 2 Data from the CFDIU to the VHF 2
 1. Possible Causes_______________
 - XCVR-VHF, 2 (1RC2) - wiring
 2. Job Set-up Information______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM AMM AMM ASM  23-12-00-740-001 23-12-33-000-001 23-12-33-400-001 31-32/03 BITE Test of the VHF SystemRemoval of the VHF Transceiver (1RC1, 1RC2, 1RC3)Installation of the VHF Transceiver (1RC1, 1RC2, 1RC3)
 3. Fault Confirmation__________________
 A. Make sure that this(these) circuit breaker(s) is(are) closed:
R  -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------121VU CFDS/CFDIU/SPLY 2TW J18 
R  **ON A/C ALL 
R  Post SB  31-1163 For A/C 155-156,208-209, 
R  121VU CFDS/CFDIU/BACK/UP  8TW  J17 
R  **ON A/C ALL
 B. Test Do the BITE test of the VHF system (Ref. AMM TASK 23-12-00-740-001).
 NOTE : Do this test for the VHF 2 only.____

 4. Fault Isolation
_______________

 A. If the test gives the maintenance message CFDIU (1TW)/VHF2 (1RC2):
 - replace the XCVR-VHF, 2 (1RC2) (Ref. AMM TASK 23-12-33-000-001) and (Ref. AMM TASK 23-12-33-400-001).
 (1) If the fault continues:
 - do a check and repair the wiring of the BUS 2 OUTPUT signal, (from VHF 2 transceiver (1RC2) pins AB/6A, 6B to the first terminal block) (Ref. ASM 31-32/03).
 B. Do the test given in Para. 3.B.
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞23-12-00∞∞∞∞∞∞∞∞∞∞Page 232
 Feb 01/05R
 CES

 TASK 23-12-00-810-821
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 COMMUNICATIONS 通訊1(69)