「一一一一一一一一一一一一一一一一一一一一一一一一T一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一T一一一一一一一一一一一一1 CFDS FAULT MESSAGES FAULT WARNINGS/MALFUNCTIONS 十一一一一一一一T一一一一一一一一一一一一一一一一一一一一一一一一T一一一一一一T一1 ISOLATION SOURCE MESSAGE ATA C PROCEDURE 十一一一一一一一一一一一一一一一一一一一一一一一一十一一一一一一一十一一一一一一一一一一一一一一一一一一一一一一一一十一一一一一一十一十一一一一一一一一一一一一1 VHF 3 VHF3 : NO DATA FROM 23XXXX 1 231300 P 209 CONTROL SOURCE T 810 809 十一一一一一一一一一一一一一一一一一一一一一一一一十一一一一一一一十一一一一一一一一一一一一一一一一一一一一一一一一十一一一一一一十一十一一一一一一一一一一一一1 VHF 3 VHF3 : NO DATA FROM 23XXXX 1 231300 P 211 CONTROL SOURCE T 810 810 十一一一一一一一1一一一一一一一一一一一一一一一一一一一一一一一一1一一一一一一1一1 IDENT: HF 1, VHF 1 十一一一一一一一一一一一一一一一一一一一一一一一一十一一一一一一一T一一一一一一一一一一一一一一一一一一一一一一一一T一一一一一一T一十一一一一一一一一一一一一1 VHF 3 VHF3 ANTENNA (4RC3)/COAX 231211 1 231200 P 211 T 810 806 L一一一一一一一一一一一一一一一一一一一一一一一一1一一一一一一一1一一一一一一一一一一一一一一一一一一一一一一一一1一一一一一一1一1一一一一一一一一一一一一」
HF/CALSEL/AEROCALL SYSTEM - FAULT ISOLATION PROCEDURES
______________________________________________________
TASK 23-11-00-810-801
Failure of the HF 1 Transceiver
1. Possible Causes
_______________
- XCVR-HF, 1 (3RE1)
- wiring
- C/B-COM NAV/HF 1 (1RE1)
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
AMM 23-11-00-740-001 Bite Test of the HF System
AMM 23-11-33-000-001 Removal of the HF Transceiver (3RE1, 3RE2)
AMM 23-11-33-400-001 Installation of the HF Transceiver (3RE1, 3RE2)
ASM 23-11/01
3. Fault Confirmation
__________________
A. Test Do the BITE test of the HF system (Ref. AMM TASK 23-11-00-740-001).
NOTE : Do this test for the HF 1 only.
____
4. Fault Isolation
_______________
A. Table of the circuit breakers used in this procedure:
-------------------------------------------------------------------------------
PANEL DESIGNATION IDENT. LOCATION
-------------------------------------------------------------------------------
R **ON A/C 001-049, 101-105, 151-199,
49VU COM/HF1 1RE1 HA14 R **ON A/C 051-099, 106-149, 201-299, 301-399,
49VU COM HF1 1RE1 HA14
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞23-11-00∞∞∞∞∞∞∞∞∞∞Page 201
May 01/05 CES
R **ON A/C ALL
R B. If the test gives the maintenance message HF1 (3RE1):
R - do a check of the circuit breaker (1RE1) status.
R (1) If the circuit breaker is closed:
R - do a check for 115VAC at pins AC/4, 5, 6 of the HF 1 transceiver
R (3RE1) (Ref. ASM 23-11/01).
R (a) If there is 115VAC:
R - replace the XCVR-HF, 1 (3RE1) (Ref. AMM TASK 23-11-33-000-001)
R and (Ref. AMM TASK 23-11-33-400-001).
R (b) If there is no 115VAC:
R - do a check for a ground signal at pin AC/8 of the HF 1
R transceiver (3RE1) (Ref. ASM 23-11/01).
R 1_ If there is no ground signal:
R - repair the wiring between the HF 1 transceiver (3RE1) pin
R AC/8 and the ground terminal (Ref. ASM 23-11/01).
R 2_ If there is a ground signal:
R - do a check of the wiring from the circuit breaker (1RE1) to
R the HF 1 transceiver (3RE1) pins AC/4, 5, 6 (Ref. ASM 23-R 11/01).
R a_ If there is no continuity:
R - repair the above wiring.
R b_ If there is continuity:
R - replace the circuit breaker (1RE1).
R (2) If the circuit breaker is open:
R - close it.
R (a) If it opens again:
R - replace the HF 1 transceiver (3RE1)(Ref. AMM TASK 23-11-33-000-R 001) and (Ref. AMM TASK 23-11-33-400-001).
R 1_ If the fault continues:
R - do a check for a short to ground at the wiring (between the
R HF 1 transceiver (3RE1) pins AC/4, 5, 6 and the circuit
R breaker (1RE1)) (Ref. ASM 23-11/01).
R a_ If there is a short to ground: 中國(guó)航空網(wǎng) m.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320 Trouble Shooting Manual 排故手冊(cè) COMMUNICATIONS 通訊1(42)
