(2)
Remove the surface protection and up to 50 mm (1.9685 in.) around the repair area with emery paper grade 100 or light grit blast (400-700) micron walnut grit.
(3)
Remove all damaged material but not more than one layer.
(4)
Feather the edges of the undamaged area to give a smooth edge to the repair area.
(5)
Make the repair area smooth with emery paper grade 280 and emery paper grade 400.
WARNING : OBEY THE MANUFACTURER'S INSTRUCTIONS WHEN YOU USE THE
_______
SPECIAL MATERIAL.
THIS MATERIAL IS DANGEROUS.
(6) Clean the repair area with CLEANING AGENTS (Material No. 11-004) and a lint-free cloth.
NOTE : Do not pour the vapor degreaser directly on the repair area.
____
Moisten the lint-free cloth with vapor degreaser.
(7)
Remove all loose and unwanted material with a vacuum cleaner.
(8)
Clean the repair area with demineralized water and a lint-free cloth. NOTE : Do not pour demineralized water directly on the repair area.
____
Moisten the lint-free cloth with demineralized water.
TASK 51-77-11-700-001
Water Break Test
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific demineralized water No specific emery paper grade 400 No specific lint-free cloth
3. Job Set-up
__________ Subtask 51-77-11-010-051
A. There is no special job set-up for this task.
4. Procedure
_________ Subtask 51-77-11-750-050
A. Do the Water Break Test
(1)
Dry the repair area with a clean lint-free cloth.
(2)
Spray a thin coating of demineralized water on the repair area. NOTE : A thick coating of demineralized water will not show all the
____
defects on the repair area.
(3)
Inspect the wetted surface to make sure the water forms a thin continuous coating.
(4)
A defect is shown when the demineralized water is repelled and forms into beads of water.
(5)
If necessary, rub down the repair area with emery paper grade 400 to remove the defect.
(6)
If necessary, clean the repair area with demineralized water and a lint-free cloth.
(7)
If necessary, repeat the water-break test until there are no defects on the repair area surface.
(8)
Dry the repair area with a clean lint-free cloth. NOTE : On completion of the water-break test, do not touch the repair
____
area. Do the repair quickly to prevent contamination.
(9)
At the repair area apply new paint as necessary (Ref. SRM 51-75-12).
TASK 51-77-11-910-008
Preparation of a Corrosion-Resistant Steel Doubler
WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL MATERIALS
_______
ONLY WITH A GOOD SUPPLY OF AIR.
OBEY THE MANUFACTURERS INSTRUCTIONS.
PUT ON PROTECTIVE CLOTHING.
DO NOT GET THEM IN YOUR MOUTH.
DO NOT SMOKE.
DO NOT BREATHE THE GAS.
THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT.
GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM STANDARD PRACTICES AND STRUCTURES(40)
