-------------------------------------------------------------------------------2001VU VACUUM TOILET SYSTEM/LAVATORY POWER A 32MG A01 2001VU VACUUM TOILET SYSTEM/LAVATORY POWER L 45MG A02 2001VU VACUUM TOILET SYSTEM/LAVATORY POWER D 39MG A03 2001VU VACUUM TOILET SYSTEM/LAVATORY POWER E 34MG A04 2001VU VACUUM TOILET SYSTEM/VACUUM SYS 35MG A06 2001VU VACUUM TOILET SYSTEM/VACUUM GEN 33MG A08
1EFF : ALL 1 38-31-61Page 403 1 1 May 01/05 1 1 1CES 1
R **ON A/C ALL
Subtask 38-31-61-010-052 R E. Get Access
(1)
Open the AFT cargo compartment door (Ref. TASK 52-30-00-860-001).
(2)
Put the access platform in position at the AFT cargo compartment door
826.
(3)
Open the access panels 161DW, 162DW.
(4)
Remove the center support strut at FR65 (Ref. TASK 53-43-11-000-001).
4. Procedure
_________
(Ref. Fig. 401/TASK 38-31-61-991-001)
Subtask 38-31-61-020-053
A. Removal of the Waste Holding Tank 3300MM WARNING : ALWAYS WEAR RUBBER GLOVES, GOGGLES AND PROTECTIVE CLOTHES WHEN
_______
YOU DO THIS TASK.
(1)
Remove the tank drain line (Ref. TASK 38-31-74-000-001).
(2)
Remove the water separator (Ref. TASK 38-31-67-000-001).
(3)
Remove the connections (29) of the rinse lines.
(4)
Disconnect the electrical connectors (16) and (17).
(5)
Remove the pipe (15) from the level transmitter 40MG.
(6)
Remove the level transmitter 40MG (Ref. TASK 38-31-62-000-001).
(7)
Remove the quick coupler clamps.
(a)
Open and remove the quick coupler clamp (26).
(b)
Move the sleeve (27) to one side.
(c)
Remove and discard the O-rings (28).
INTENTIONALLY BLANK
R 1 1
38-31-61Page 405
1 1 Aug 01/01 1 1 1CES 1
Waste Holding Tank 3300MM Figure 401/TASK 38-31-61-991-001- 12 (SHEET 1)
1EFF : 1 1R 1CES ALL 1 11 1 38-31-61 Page 406 Aug 01/01
Waste Holding Tank 3300MM Figure 401/TASK 38-31-61-991-001- 22 (SHEET 2)
1EFF : 1 1R 1CES ALL 1 11 1 38-31-61 Page 407 Aug 01/01
(8)
Remove the nuts (25) and the washers (24).
(9)
Remove the bolts (21) and the washers (22).
(10)
Remove the clamps (23).
(11)
Remove the bolts (18) and the washers (19).
(12)
Remove the bracket (20).
(13)
Remove the waste pipes (3), (4), (7) and (8).
(14)
Put blanking plugs on the disconnected line ends.
(15)
Put blanking caps on the disconnected electrical connectors. NOTE : Put a mark on the tank and the mounting bracket to find the
____
installation position again.
(16)
Remove the clamps (2).
(17) Remove the waste holding tank 3300MM (1). Subtask 38-31-61-860-050
B. Removal of the Components
(1) If necessary remove the level sensor 41MG from the waste holding tank 3300MM. (Ref. TASK 38-31-63-000-001).
1EFF : ALL 1 38-31-61Page 408 1 1 Aug 01/01R 1 1 1CES 1
TASK 38-31-61-400-001 Installation of the Waste Holding Tank (3300MM) WARNING : DO NOT DO WORK ON THE TOILET WASTE SYSTEM AND THE POTABLE WATER
_______ SYSTEM AT THE SAME TIME. THIS WILL PREVENT CONTAMINATION OF THE POTABLE WATER SYSTEM. SUCH CONTAMINATION CAN BE DANGEROUS TO HEALTH.
WARNING : ALWAYS USE RUBBER GLOVES WHEN YOU DO WORK:
_______
-
ON THE TOILET WASTE SYSTEM, OR
-
ON PARTS THAT HAVE CONTAMINATION FROM THE WASTE SYSTEM.
WHEN YOU COMPLETE THE WORK PROCEDURE, CLEAN YOUR HANDS WITH SOAP AND
WATER.
THIS WILL PREVENT INFECTION (TOILET WASTE IS DANGEROUS FOR HEALTH).
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WATER/WASTE 2(72)
