-------------------------------------------------------------------------------PANEL SERVICE IDENT. LOCATION -------------------------------------------------------------------------------2001VU VACUUM TOILET SYSTEM/LAVATORY POWER A 32MG A01 2001VU VACUUM TOILET SYSTEM/LAVATORY POWER L 45MG A02 2001VU VACUUM TOILET SYSTEM/LAVATORY POWER D 39MG A03 2001VU VACUUM TOILET SYSTEM/LAVATORY POWER E 34MG A04 2001VU VACUUM TOILET SYSTEM/VACUUM SYS 35MG A06 2001VU VACUUM TOILET SYSTEM/VACUUM GEN 33MG A08
**ON A/C ALL
Subtask 38-31-41-860-050
C. Preparation for Installation
(1) Clean the component interface and/or the adjacent area.
**ON A/C 001-003, 051-061,
(Ref. Fig. 401/TASK 38-31-41-991-003) R **ON A/C 004-049, 062-099, 101-149, 151-199, 201-299, 301-399, 401-499,
(Ref. Fig. 401A/TASK 38-31-41-991-003-A)
**ON A/C ALL
(2) Apply COMMON GREASE (Material No. 04-008) to the new O-rings (4).
4. Procedure
_________
Subtask 38-31-41-420-053
A. Installation of the Toilet Assembly
**ON A/C 001-003, 051-061,
(Ref. Fig. 401/TASK 38-31-41-991-003)
R **ON A/C 004-049, 062-099, 101-149, 151-199, 201-299, 301-399, 401-499,
(Ref. Fig. 401A/TASK 38-31-41-991-003-A) **ON A/C ALL
(1)
Put the toilet assembly (9) in position.
(2)
Install the washers (13) and (12) and the bolts (11).
(3)
Make sure that the filter (2) is installed in the fitting (1). NOTE : If the filter (2) is not installed, this can cause the rinse
____ valve to stay open.This could result in possible flooding of the Electrical Compartment (EC) or areas below the toilet.
(4)
Connect the water line (3).
(5)
Install new packings (4) on the flush lines.
(6)
Put the sleeve (5) in position.
(7)
Install the coupler clamp (6).
(8)
Connect the electrical connector (10) 50MG-A to the flush control unit (7).
(9)
Open the shutoff valve (8). Subtask 38-31-41-613-050
B.
Service the toilet system (Ref. TASK 12-16-38-613-001). Subtask 38-31-41-710-050
C. Operate the toilet and make sure that it flushes correctly (Ref. TASK 38-31-00-710-009).
Subtask 38-31-41-790-050
D. Leak Test
(1)
Do the leak test of the toilet system (Ref. TASK 38-31-00-790-002).
(2)
Record the result of the test.
(3)
Compare the result of the test before the removal and after the installation.
NOTE : The differance between the tests must not be more than 10% of
____
the result made before the removal.
5. Close-up
________ Subtask 38-31-41-410-053-A
A. Close Access
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Install the toilet shroud (Ref. TASK 25-45-22-400-001).
(3) Put the system back to the serviceable condition. Subtask 38-31-41-862-050
B. De-energize the ground service network
(Ref. TASK 24-42-00-862-001).
VALVE - WATER - REMOVAL/INSTALLATION____________________________________
TASK 38-31-55-000-001
Removal of the Water Valve
R R R WARNING : DO NOT DO WORK ON THE TOILET WASTE SYSTEM AND THE POTABLE WATER_______ SYSTEM AT THE SAME TIME. THIS WILL PREVENT CONTAMINATION OF THE POTABLE WATER SYSTEM. SUCH CONTAMINATION CAN BE DANGEROUS TO HEALTH.
R R R R R R WARNING : ALWAYS USE RUBBER GLOVES WHEN YOU DO WORK:_______ - ON THE TOILET WASTE SYSTEM, OR - ON PARTS THAT HAVE CONTAMINATION FROM THE WASTE SYSTEM. WHEN YOU COMPLETE THE WORK PROCEDURE, CLEAN YOUR HANDS WITH SOAP AND WATER. THIS WILL PREVENT INFECTION (TOILET WASTE IS DANGEROUS FOR HEALTH).
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WATER/WASTE 2(57)
