In the vacuum system:
-
the vacuum blower does not operate.
-
the flush valve operates and 0.2 l
(0.05 USgal) of water flows into thetoilet bowl.
NOTE : At the end of each flush cycle
____ the status of the toilet is updated. The NO FAULT light will stay on if no faults are found during this cycle.
On the FCU tester IIA:
-
the NO FAULT light goes off.
-
the NO POWER to FCU or DISABLE light is on.
NOTE : If necessary you can cancel a
____ flush cycle when you push the RESET pushbutton.
NOTE : During the complete test:
____
-
the TOILET INOP light on the Flight Attendant Panel (FAP) is on.
-
the Vacuum System Controller (VSC) receives no data that the FCU is powered, this is normal and should be ignored,
-
the VSC has no effect on the toilet operation, but will still control the vacuum blower.
-
the faults shown are not stored in the VSC Electrically Erasable Programmable Read Only Memory (EEPROM).
R 1EFF : 001-049, 051-099, 101-105, 151-199, 1 38-31-00Page 536 1201-299, 1May 01/05 1 1 1CES 1
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------NOTE : The FCU tester IIA is defective
____ if:
-two or more red lights are ON,
-the NO FAULT light and also one of the red lights are ON.
R **ON A/C 106-149, 301-399, 401-499,
Subtask 38-31-00-720-050-A
A. Do this Test.
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the FCU tester IIA: On the FCU tester IIA:
- put the power switch to the POWER position. - the green light INPUT POWER comes on.- the NO FAULT light comes on and stays
on.
NOTE : If the NO FAULT light goes off____ after a few seconds (then there is a fault in the system) and one of the subsequent lights will come on:
- the open position limit switch, - the close position limit switch, - the rinse water solenoid, - the FCU internal faults, - the flush valve motor, - the no power to FCU or disabled.
2. On the FCU tester IIA: On the FCU tester IIA:
- push the flush pushbutton. - the FLUSH CYCLE light comes ON.
In the vacuum system: - the vacuum blower operates for 15 s. - the toilet flush cycle functions and the toilet flushes.
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
3. On the FCU tester:
-turn the blower switch to the BLOWER OFF position.
-push and hold the flush pushbutton.
4. On the FCU tester IIA:
-release the blower switch to the NORMAL position.
5. On the FCU tester IIA:
-put the ENABLE/DISABLE switch to the DISABLE position.
In the vacuum system:
-
the vacuum blower does not operate.
-
the flush valve operates and 0.2 l
(0.05 USgal) of water flows into thetoilet bowl.
NOTE : At the end of each flush cycle
____ the status of the toilet is updated. The NO FAULT light will stay on if no faults are found during this cycle.
On the FCU tester IIA:
-
the NO FAULT light goes off.
-
the NO POWER to FCU or DISABLE light is on.
NOTE : If necessary you can cancel a
____ flush cycle when you push the RESET pushbutton.
NOTE : During the complete test:
____
-
the VACUUM SYSTEM DISABLED message on the WATER/WASTE page on the Flight Attendant Panel (FAP) is shown.
-
the DUE B receives no data that the FCU is powered, this is normal and should be ignored,
NOTE : The FCU tester IIA is defective
____ if:
-two or more red lights are ON,
-the NO FAULT light and also one of the red lights are ON.
R 1EFF : 106-149, 301-399, 401-499, 1 38-31-00Page 538 1 1 Aug 01/05 1 1 1CES 1 **ON A/C ALL
5. Close-up
________ Subtask 38-31-00-410-067
A. Close Access
(1)
Disconnect the electrical connector 50MG-A, 50MG1-A, 50MG2-A 50MG3-A or 50MG4-A from the FCU tester IIA.
(2)
Disconnect the electrical connector of the FCU tester IIA from the FCU.
(3)
Remove the FCU tester IIA.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WATER/WASTE 2(21)
