B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External
Power 38-10-00-614-002 Depressurization of the Potable Water System 52-10-00-010-001 Opening of the Passenger/Crew Door 52-30-00-860-001 Open the FWD or AFT Cargo-Compartment Door with the
Yellow Electric Pump 38-14-49-991-004 Fig. 401
3. Job Set-up
__________
Subtask 38-14-49-861-051
A. Energize the ground service network (Ref. TASK 24-42-00-861-001).
Subtask 38-14-49-010-053
B. Get Access
(1) Put an access platform in position in front of the applicable passenger/crew door 832 or 842.
(2)
Open the passenger/crew door 832 or 842 (Ref. TASK 52-10-00-010-001). Subtask 38-14-49-680-059
C.
Depressurize the potable water system (Ref. TASK 38-10-00-614-002).
Subtask 38-14-49-010-054
D. Get Access
(1)
Put an access platform in position at the drain panel 133AL.
(2)
Open the drain panel 133AL.
(3)
In the drain panel, put warning notice to tell persons not to turn the control handle.
(4)
Put an access platform in position at the service panel 2023VU.
(5)
Open the access door 171AL of the service panel 2023VU.
(6)
In the service panel 2023VU put the warning notice to tell persons not to turn the control handle.
(7)
Put an access platform in position at the FWD cargo-compartment door
825.
(8)
Open the FWD cargo-compartment door 825 (Ref. TASK 52-30-00-860-001).
(9)
Set the CARGO COMPT LIGHT switch 6LU to ON.
(10) In the FWD cargo-compartment, remove the sidewall panel 131HW and the R floor panels 131EF, 131FF, 131GF.
Subtask 38-14-49-865-053
E. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
124VU SVCE/601PP/602PP/SPLY 1PX BB01
4. Procedure
_________
(Ref. Fig. 401/TASK 38-14-49-991-004) Subtask 38-14-49-020-051
A. Remove the Control Cable
NOTE : If necessary remove the insulation sleeve.
____
(1)
Remove the nuts (1), the washers (2) and the clamps (3).
(2)
Cut the tie-down strap (17) (see detail D).
(3)
Disconnect the lead-bonding
(a) Remove the nut (18), the washer (19) and disconnect the lead-bonding (20) (see detail C).
(4)
At the clevis (11):
(a)
Remove and discard the cotter pin (4), and remove the washer (5).
(b)
Remove the pin (6) from the clevis (11).
(c)
Remove and discard the lockwire at the locknut (10).
(d)
Remove the clevis (11) and the locknut (10) from the cable (9).
(5)
At the sliding end (8):
(a)
Remove and discard the cotter pin (4), and remove the washer (5).
(b)
Remove the pin (6) from the sliding end (8).
(c)
Loosen the self-locking nut (7) but do not remove it.
(d)
Turn the sliding end (8) clockwise and remove it from the cable (9).
(6)
Pull the cable (9) cut of the rigid sleeve (15) and the swivel ends (12).
(7)
Loosen the hollow hex head screws (16) at the swivel ends (12) and remove the rigid sleeve (15).
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM WATER/WASTE 1(99)
