-------------------------------------------------------------------------------
PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------**ON A/C ALL
 121VU EIS/HORN/SPLY 2WC P09 121VU HYDRAULIC/LGCIU/SYS2 2GA Q35 121VU HYDRAULIC/LGCIU/SYS1/GRND SPLY 52GA Q34

R **ON A/C 062-099, 106-149, 151-199, 204-299, 301-399, 401-499,
 121VU ADIRS/ADIRU/2PWR/SHED 10FP N10 121VU ADIRS/ADIRU/3PWR/SWTG 9FP N09 121VU ADIRS/ADIRU/2/26VAC AND AOA 5FP2 N08 121VU ADIRS/ADIRU/3/26VAC AND AOA 5FP3 N07 121VU ADIRS/ADIRU/2/115VAC 4FP2 N06 121VU ADIRS/ADIRU/3/115VAC 4FP3 N05 121VU ADIRS/ADIRU/2/28VDC 6FP2 N04 121VU ADIRS/ADIRU/3/28VDC 6FP3 N03
 1EFF : ALL 1 34-11-00Page 514 1 1 Aug 01/05 1 1 1CES 1

 **ON A/C ALL

 4. Procedure
_________

R **ON A/C 001-049, 101-105, 151-199, 201-203,
 Subtask 34-11-00-710-051-A
 A. Test of the Monitoring of the ADIRS Power Supply (115VAC-28VDC) NOTE : Ignore all warnings / indications which are not related to this
____
 test.

 -------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1.
 On the panel 49VU (121VU):

 - open the circuit breaker 4FP1 (4FP2).

 2.
 On the ADIRS CDU:

 -
set the OFF/NAV/ATT selector switch related to the IR 1 (IR 2) to NAV.

 -
set the SYS DISPLAY selector switch to 1 (2).

3.
 On the panel 49VU (121VU):

 -close the circuit breaker 4FP1 (4FP2).
- on the ADIRS CDU:
*
 the ON BAT light is on,

 *
 the related ALIGN legend is on,

 *
 the related FAULT legend flashes.

 - on the upper ECAM display unit, the IR 1 FAULT (IR 2 FAULT) warning comes into view.
 - on the GLARESHIELD panels 130VU and 131VU, the MASTER CAUT lights are on.
 -you can hear the single chime.
 -after a time delay of 15 s, you can hear the horn.
- on the ADIRS CDU:
*
 the related FAULT legend goes off,

 *
 the ON BAT light goes off,

 *
 the related ALIGN legend stays on.

 1EFF : ALL 1 34-11-00Page 515 1 1 May 01/05 1 1 1CES 1

 -------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
- on the upper ECAM display unit, the
 IR1 FAULT (IR2 FAULT) warning goes
 out of view.
 - the horn stops.
 4. On the ADIRS CDU:
 - set the OFF/NAV/ATT selector  - on the ADIRS CDU, the related ALIGN
 switch related to the IR 1 (IR  legend goes off.
 2) to OFF.
 5. On the GLARESHIELD panels 130VU
 and 131VU:
 - push and release the MASTER  - on the GLARESHIELD panels 130VU and
 CAUT lights.  131VU, the MASTER CAUT lights go off.
 6. Do the IR 2 test as specified in  You must get the same results on the
 para. 1 to 5.  F/O side.
 7. On the ADIRS CDU:
 - set the OFF/NAV/ATT selector  - on the ADIRS CDU:
 switch related to the IR 1 (IR  * the related ALIGN legend comes on,
 2) to NAV.  * then, the ON BAT light comes on
 during 5 s.
 8. On the panel 49VU (121VU):
 - open the circuit breaker 4FP1  - on the ADIRS CDU, the ON BAT light
 (4FP2).  comes on.
 - in the nose gear well:
 * after a time delay of 15 s approx
 you can hear the horn,
 * on the door 121AL, on the EXT PWR
 panel 108VU, the ADIRU & AVNCS VENT
 light comes on.
 - on the CAPT (F/O) PFD, the attitude
 indications are shown.
 9. On the panel 49VU (121VU):
 - close the circuit breaker 4FP1  - on the ADIRS CDU, the ON BAT light
 (4FP2).  goes off. 

R 1EFF : 001-049, 101-105, 151-199, 201-203, 1 34-11-00Page 516 1 1 May 01/05 1 1 1CES 1

 -------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
10. On the ADIRS CDU:
 -set the OFF/NAV/ATT selector switch related to the IR 1 (IR 2) to OFF.
11.
 Do the IR 2 test as specified in para. 7 to 10.

12.
 On the panel 121VU: - open the circuit breaker 4FP3.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM NAVIGATION 導航1(70)