822.
(2)
Open the access door 822.
(3)
On the battery power center 105VU:
-loosen the two screws and remove the protective cover.
1EFF : ALL 1 34-11-00Page 507 1 1 Feb 01/98 1 1 1CES 1 Subtask 34-11-00-860-052
B. Aircraft Maintenance Configuration
(1)
Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002).
(2)
Do the EIS start procedure (Ref. TASK 31-60-00-860-001).
(3)
On the overhead panel:
- on the FLT CTL panels 23VU and 24VU, make sure that the FAC, ELAC and SEC pushbutton switches are not pushed (in). The OFF legends are on.
- on the ELEC panel 35VU, make sure that the battery voltage is correct, between 26VDC and 30VDC. - on the ADIRS CDU, make sure that the 3 OFF/NAV/ATT selector switches are at OFF.
NOTE : This test is for the system 1. For the systems 2 and 3, use
____ the indications between the parentheses.
Subtask 34-11-00-865-053
C. Make sure that this(these) circuit breaker(s) is(are) closed:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU L/G/LGCIU/SYS1/NORM 1GA C09 49VU NAV PROBES/ADIRU 1/AND AOA 1/26VAC 5FP1 F07 49VU NAV PROBES/ADIRU1/115VAC 4FP1 F06
105VU ADIRS/ADIRU1/28VDC 6FP1 C02
R **ON A/C 001-049, 051-061, 101-105, 201-203,
121VU ADIRS/ADIRU/2PWR/SHED 10FP N11 121VU ADIRS/ADIRU/3PWR/SWTG 9FP N10 121VU ADIRS/ADIRU/2/26VAC AND AOA 5FP2 N09 121VU ADIRS/ADIRU/3/26VAC AND AOA 5FP3 N08 121VU ADIRS/ADIRU/2/115VAC 4FP2 N07 121VU ADIRS/ADIRU/3/115VAC 4FP3 N06 121VU ADIRS/ADIRU/2/28VDC 6FP2 N05 121VU ADIRS/ADIRU/3/28VDC 6FP3 N04
1EFF : ALL 1 34-11-00Page 508 1 1 May 01/05 1 1 1CES 1
-------------------------------------------------------------------------------
PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------**ON A/C ALL
121VU EIS/HORN/SPLY 2WC P09 121VU HYDRAULIC/LGCIU/SYS2 2GA Q35 121VU HYDRAULIC/LGCIU/SYS1/GRND SPLY 52GA Q34
R **ON A/C 062-099, 106-149, 151-199, 204-299, 301-399, 401-499,
121VU ADIRS/ADIRU/2PWR/SHED 10FP N10 121VU ADIRS/ADIRU/3PWR/SWTG 9FP N09 121VU ADIRS/ADIRU/2/26VAC AND AOA 5FP2 N08 121VU ADIRS/ADIRU/3/26VAC AND AOA 5FP3 N07 121VU ADIRS/ADIRU/2/115VAC 4FP2 N06 121VU ADIRS/ADIRU/3/115VAC 4FP3 N05 121VU ADIRS/ADIRU/2/28VDC 6FP2 N04 121VU ADIRS/ADIRU/3/28VDC 6FP3 N03
**ON A/C ALL
4. Procedure
_________
Subtask 34-11-00-710-050
A. Test of the Monitoring of the ADR/AOA 26VAC Power Supply
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the ADIRS CDU:
-set the OFF/NAV/ATT selector - the CAPT and F/O PFDs show the speed switch related to the IR1, IR2 and altitude indications. and IR3 to NAV.
2. On the panel 49VU (121VU):
- open the circuit breaker 5FP1 - on the ADIRS CDU, the FAULT legend of (5FP2). the ADR1 (ADR2) pushbutton switch comes on.
1EFF : ALL 1 34-11-00Page 509 1 1 Aug 01/05 1 1 1CES 1
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
3. On the panel 8VU:
-set the AIR DATA selector
switch to CAPT/3 (F/O/3).
4.
On the panel 121VU: - open the circuit breaker 5PF3.
5.
On the panel 49VU (121VU):
-close the circuit breaker 5FP1 (5FP2).
6.
On the panel 8VU:
-set the AIR DATA selector
switch to NORM.
7.
On the panel 121VU:
-close the circuit breaker 5FP3.
- on the CAPT (F/O) PFD, the SPD and ALT warning flags come into view.
- on the lower ECAM DU, on the status page, in the INOP SYST section, the ADR1 indication comes into view.
- on the CAPT (F/O) PFD, the speed andaltitude indications come into view.
- on the CAPT (F/O) PFD, the SPD and ALT warning flags come into view.
- on the lower ECAM display unit, in the INOP SYST section, the ADR 1 + 3 (ADR 2 + 3) indication comes into view.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM NAVIGATION 導航1(68)
