R **ON A/C 001-049, 052-099, 101-149, 201-299,
30-71-17-991-001 Fig. 401 R **ON A/C 051-051,
R 30-71-17-991-001-A Fig. 401A
R 1EFF : 001-049, 051-099, 101-149, 201-299, 1 30-71-17Page 401 1 1 Config-1 May 01/05 1 1 1CES 1
**ON A/C 001-049, 051-099, 101-149, 201-299,
3. Job Set-up
__________
Subtask 30-71-17-861-050
A. Energize the ground service network
(Ref. TASK 24-42-00-861-001).
Subtask 30-71-17-865-050
B. Open, safety and tag this(these) circuit breaker(s): -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
R C/B NOT APPLICABLE **ON A/C 001-049, 052-099, 101-149, 201-299,
Subtask 30-71-17-010-050
C. Get Access
(1)
Put an access platform in position at the FWD-cargo compartment-door
825.
(2)
Open the FWD-cargo compartment-door 825 (Ref. TASK 52-30-00-860-001).
(3)
Set the CARGO COMPT LIGHT switch 6LU to ON.
(4) In the FWD cargo compartment, remove the panel 131HW.
**ON A/C 051-051,
Subtask 30-71-17-010-050-A
C. Get Access
(1)
Put an access platform in position at the FWD-cargo compartment-door
825.
(2)
Open the FWD-cargo compartment-door 825 (Ref. TASK 52-30-00-860-001).
(3)
Set the CARGO COMPT LIGHT switch 6LU to ON.
(4) In the FWD cargo compartment, remove the floor panels 131SF, 132SF. **ON A/C 001-049, 051-099, 101-149, 201-299,
4. Procedure
_________ **ON A/C 001-049, 052-099, 101-149, 201-299,
(Ref. Fig. 401/TASK 30-71-17-991-001) **ON A/C 051-051,
(Ref. Fig. 401A/TASK 30-71-17-991-001-A) **ON A/C 001-049, 051-099, 101-149, 201-299,
Subtask 30-71-17-020-050
A. Removal of the Sensor
(1)
Cut and discard the cable ties of the identification and warning labels.
(2)
Remove the velcro tape (1) that attaches the sleeve (3) around the sensor.
(3)
Remove the sleeve (3) from around the clamp sensor assembly (6) and the clamp (2).
(4)
Disconnect the two wires of the clamp sensor assembly (6) from the terminal strip.
(5)
Put blanking caps on the disconnected electrical connectors.
(6)
Remove the screws (4) and (5) from the clamp (2) and the clamp sensor assembly (6).
(7)
Remove the clamp (2).
(8)
Remove the clamp sensor assembly (6).
1EFF : 001-049, 051-099, 101-149, 201-299, 1 30-71-17Page 403 1 1 Config-1 Aug 01/05R 1 1 1CES 1
Waste-Water De-icing Sensor
Figure 401/TASK 30-71-17-991-001
R 1EFF : 001-049, 052-099, 101-149, 201-299, 1 30-71-17Page 404 1 1 Config-1 May 01/05 1 1 1CES 1R Waste-Water De-icing Sensor R Figure 401A/TASK 30-71-17-991-001-A
R 1EFF : 051-051, 1 30-71-17Page 405 1 1 Config-1 May 01/05 1 1 1CES 1
INTENTIONALLY BLANK
R 1 1
30-71-17Page 406
1 1 Config-1 Aug 01/05 1 1 1CES 1 TASK 30-71-17-400-001
Installation of the Waste-Water De-icing Sensor (40DU)
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific access platform 2 m (6 ft. 7 in.)
B. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External Power 24-42-00-862-001 De-energize the Ground Service Network Supplied from the External Power 30-71-00-710-002 Operational Test of the Waste-Water Ice-Protection Heater-Elements 52-30-00-860-001 Open the FWD or AFT Cargo-Compartment Door with the Yellow Electric Pump 52-30-00-860-002 Close the FWD or AFT Cargo-Compartment Door with the Yellow Electric Pump
R **ON A/C 001-049, 052-099, 101-149, 201-299,
30-71-17-991-001 Fig. 401
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM ICE AND RAIN PROTECTION 防冰和排雨2(61)
