-------------------------------------------------------------------------------
REFERENCE DESIGNATION -------------------------------------------------------------------------------
29-22-51-400-001 Installation of the Ram Air Turbine 2140GE (for
corrective action)
29-22-52-000-001 Removal of the RAT Ground Check Module (2027GE) (for corrective action)
29-22-52-400-001 Installation of the RAT Ground Check Module (2027GE) (for corrective action)
3. Job Set-up
__________
Subtask 29-00-00-860-084
A. Aircraft Maintenance Configuration
(1)
Put the safety barriers in position adjacent to the location of the RAT (forward of the left main door of the main landing gear).
(2)
Energize the aircraft electrical circuits (Ref. TASK 24-41-00-861-002).
Subtask 29-00-00-010-065
B. Get Access
(1)
Open the access door 197EB.
Subtask 29-00-00-865-076
C.
Make sure that this(these) circuit breaker(s) is(are) closed:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------106VU CSM/G /EV/MAN/SPLY 6XE B04 121VU HYDRAULIC/RAT/SPLY/EXTN/SOL1 2803GE P33
R **ON A/C 001-049, 051-061, 101-102, 201-202,
121VU HYDRAULIC/RAT/CTL 2801GE P32
R 1EFF : 001-049, 051-061, 101-105, 201-203, 1 29-00-00Page 254 1 1 May 01/05 1 1 1CES 1
-------------------------------------------------------------------------------
PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------R **ON A/C 103-105, 203-203,
121VU HYD/RAT/CTL 2801GE P32 R **ON A/C 001-049, 051-061, 101-105, 201-203,
Subtask 29-00-00-865-077
D. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
105VU ELEC/CSM/G /EV AUTO/SPLY 7XE C01
4. Procedure
_________
Subtask 29-00-00-710-056
A. Operational Test WARNING : MAKE SURE THAT THE RAT TRAVEL RANGE IS CLEAR BEFORE YOU
_______
EXTEND/RETRACT THE RAT.
NOTE : A second person must examines the extension of the RAT before you
____
push the RAT MAN ON pushbutton.
NOTE : Do not operate the RAT deployment solenoids for more than 60
____ seconds. You can operate them more than once during the test. When the total operation time (solenoid energized) is 60 seconds, you must let the solenoids cool for 30 minutes.
R 1EFF : 001-049, 051-061, 101-105, 201-203, 1 29-00-00Page 255 1 1 May 01/05 1 1 1CES 1 (1) Do this test
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the overhead panel 40VU: At the RAT:
-lift the cover and push the RAT - the RAT extends.
MAN ON switch.
2.
Retract the RAT (Ref. TASK 29-22- - the RAT returns to its stowage. 00-869-002).
3.
On the overhead panel 21VU: At the RAT:
-lift the cover and push the MAN - the RAT extends.
ON/AUTO switch in the EMER ELEC
PWR section.
Subtask 29-00-00-860-085
B. Preparation for the Bleeding Procedure
(1)
Install the PROTECTION EQUIPMENT - RAT.
(2)
Connect the CONTROL UNIT - RAT (682003008) to the ground test connector of the RAT ground control panel 2815GE.
(3)
Pressurize the Blue hydraulic system with the ground power cart (Ref. TASK 29-10-00-863-003).
NOTE : For the test of the function of the RAT-governor including the
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM HYDRAULIC POWER 液壓1(62)
