曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

Mixture Description Exhaust Gas Temperature
Best Power 75°F Rich Of Peak EGT
Best Economy 50°F Lean Of Peak EGT
March 2010
4-20 Information Manual
Section 4 Cirrus Design
Normal Procedures SR22
Landing
• Caution •
Landings should be made with full flaps. Landings with less
than full flaps are recommended only if the flaps fail to deploy
or to extend the aircraft’s glide distance due to engine
malfunction. Landings with flaps at 50% or 0%; power should
be used to achieve a normal glide path and low descent rate.
Flare should be minimized.
Normal Landing
Normal landings are made with full flaps with power on or off. Surface
winds and air turbulence are usually the primary factors in determining
the most comfortable approach speeds.
Actual touchdown should be made with power off and on the main
wheels first to reduce the landing speed and subsequent need for
braking. Gently lower the nose wheel to the runway after airplane
speed has diminished. This is especially important for rough or soft
field landings.
Short Field Landing
For a short field landing in smooth air conditions, make an approach at
77 KIAS with full flaps using enough power to control the glide path
(slightly higher approach speeds should be used under turbulent air
conditions). After all approach obstacles are cleared, progressively
reduce power to reach idle just before touchdown and maintain the
approach speed by lowering the nose of the airplane. Touchdown
should be made power-off and on the main wheels first. Immediately
after touchdown, lower the nose wheel and apply braking as required.
For maximum brake effectiveness, retract the flaps, hold the control
yoke full back, and apply maximum brake pressure without skidding.
Crosswind Landing
Normal crosswind landings are made with full flaps. Avoid prolonged
slips. After touchdown, hold a straight course with rudder and brakes
as required. The maximum allowable crosswind velocity is dependent
upon pilot capability as well as aircraft limitations. Operation in direct
crosswinds of 20 knots has been demonstrated.
March 2010
Cirrus Design Section 4
SR22 Normal Procedures
Information Manual 4-21
Balked Landing/Go-Around
In a balked landing (go around) climb, disengage autopilot, apply full
power, then reduce the flap setting to 50%. If obstacles must be
cleared during the go around, climb at 75-80 KIAS with 50% flaps.
After clearing any obstacles, retract the flaps and accelerate to the
normal flaps up climb speed.
1. Autopilot .....................................................................DISENGAGE
2. Power Lever ........................................................FULL FORWARD
3. Flaps ........................................................................................50%
4. Airspeed........................................................................75-80 KIAS
After clear of obstacles:
5. Flaps .........................................................................................UP
After Landing
1. Power Lever ................................................................... 1000 RPM
2. Fuel Pump ...............................................................................OFF
3. Flaps ..........................................................................................UP
4. Transponder ...........................................................................STBY
5. Lights ..................................................................... AS REQUIRED
6. Pitot Heat .................................................................................OFF
• Note •
As the airplane slows the rudder becomes less effective and
taxiing is accomplished using differential braking.
March 2010
4-22 Information Manual
Section 4 Cirrus Design
Normal Procedures SR22
Shutdown
1. Fuel Pump (if used) .................................................................OFF
2. Throttle ....................................................................................IDLE
• Caution •
Note that the engine hesitates as the switch cycles through
the “OFF” position. If the engine does not hesitate, one or both
magnetos are not grounded. Prominently mark the propeller
as being “Hot,” and contact maintenance personnel
immediately.
3. Ignition Switch .....................................................................CYCLE
4. Mixture ............................................................................. CUTOFF
5. All Switches..............................................................................OFF
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：西銳20飛機信息手冊 SR22 AIRPLANE INFORMATION MANUAL 2979(36)