曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

1.3 Airfield operating minima
A proposal for airfield operating minima for each airfield intended to be used by the operator.
1.4 Flight crew training
A syllabus for ground training, flight/simulator training in order to get the Category II or III qualification and the requirements for recurrent training.
1.5 Flight crew procedures
A description of the operational procedures covering in particularcrew task sharing, approach monitoring, decision making, handling of failures and go-around.
1.6 Maintenance program
A description of the maintenance program, which is mandatory to ensure the airborne equipment, will remain at the level of performance and reliability demonstrated during the certification.
2.
After receiving this file, the authority will meet the operator to review the file and to notify the required operational demonstration.

3.
The operator has to establish a simulator training program to qualify both instructors and pilots on the aircraft type.

4.
During the operational demonstration, the operator must demonstrate his ability to perform Category II or III with an appropriate approach success rate and level of safety.

5.
If the operational demonstration is satisfactory, the operator will obtain the approval for in-fine service with the specified minima.

6.
During fine operations, the operator must provide periodic flight reports with all required data to the authority as part of a continuous monitoring process.

The complete Category II and Category III approval process is illustrated in Figure 3.2.
3.1.3 CREATION OF A FILE FOR THE SUBMISSION
In order to help operators to create an operational approval file, the following is provided.
1.
Basis for establishment of the DH and RVR minima, tables of acceptable minima . paragraph 3.2 Operating Aerodrome Minima .

2.
Complete FAA/JAA requirements for crew training and qualification and Airbus training program . paragraph 3.4 Crew Training .

3.
Requirements for flight crew procedures and examples of Airbus procedures . paragraph 3.3 Flight procedures .

4.
Basis for aircraft maintenance . paragraph 3.5 Maintenance .

5.
Summary of airworthiness requirements for CAT II / CAT III and autoland certifications . Chapter 4 Aircraft requirements .

6.
Standards for an airfield to be CAT II / CAT III approved . Chapter 5 Aerodrome requirements .

Figure 3.2 Illustration of approval process

3.2 OPERATING MINIMA
3.2.1 DEFINITION
In the ICAO document "Manual of All Weather Operations" will be found the following definition of the term 'Aerodrome Operating Minima'.
The limits of usability of an aerodrome for either take-off or landing, usually expressed in terms of visibility or runway visual range, decision altitude (DA/DH) or minimum descent altitude/height (MDA/MDH) and cloud conditions.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：getting to grips with CAT II CAT III operations(12)