.  Check of Dimension LV

.  Determination of N1 Speed Sensor Adjustment Plate Thickness

.  Installation of No.1 and No.2 Bearing Support on Storage Stand

.  Final Inspection

.  Preliminary Inspection

.  Installation of Fan Frame Strut Internal & External Parts

.  Installation of Brackets on Fan Frame Flanges

.  Installation of Vibration Sensor Rear Guide Tube and Monitoring Parts

.  Installation of Variable Bleed Valve (VBV) System

.  Installation of Internal Parts on Fan Frame

.  Installation of Oil Tank Assembly and External Tubing on Fan Frame

.  Final Inspection

.  Preliminary Inspection

.  Installation of Blades in Stage 4-9 Spool

.  Installation of Blades in Stage 1-2 Spool

.  Balancing of Stage 1-2 Spool

.  Installation of Blades into Stage 3 Disk

.  Balancing of Stage 3 Disk

.  Installation of Compressor Rear Rotating (CDP) Air Seal

.  Preliminary Compressor Rotor Balance before Tip Grind

.  Tip Grind on Compressor Rotor Blade

.  Compressor Rotor Final Balance after Tip Grind

.  Final Inspection

Titanium Compressor Front Stator Assembly (Configuration One)
.  Preliminary Inspection

.  Installation of Anti-rotation Stop

.  Installation of Stage 5 Bleed Manifold Segments

.  Installation of Compressor Stator Case Half on Installation Stand

.  Installation of Stage 1, 2,3 and 4 Liner Sector Guides and Liner for Liner Gap Measurement

.  Apply RTV to Stage 1, 2 and 3 Liner Segments

.  Installation of Stage 1, 2 and 3 Liner Segments

.  Installation of Stage 4 and 5 Sector Guides, Vane Sectors and Stationary Seals for Gap Measurement

.  Installation of Stage 5 Liners

.  Installation of Stage 4 and 5 Vane Sectors

.  Assembly IGV, Stage 1, 2 and 3 Actuation Rings

.  Installation of Stage 3 vanes, Lever Arms, Actuation Ring, Shrouds and Bushings

.  Installation of Stage 2 vanes, Lever Arms, Actuation Ring, Shrouds and Bushings

Steel Compressor Front Stator Assembly (Configuration Two)
.  Installation of IGV’s, Lever Arms, Actuation Ring, Shrouds and Bushings

.  Measure Stage 1, 2 and 3 Shroud Circumferential Clearance (End Gaps)

.  Apply RTV to Stage 1, 2 and 3 Shrouds and Pins

.  Installation of Stage 1, 2 and 3 Shroud Seal Retainers

.  Assembly of Case Halves

.  Measure Circumferential Clearance of IGV Shrouds, IGV Seal Retainers and Stage 1, 2 & 3 Retainers
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：CFM 56-3 Engine Disassembly and Assembly Capability(10)