曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

4)  Place the airplane in the AIR MODE.  See the maintenance manual for instructions to place the airplane in AIR MODE (AMM 32-09-02-042-001)
5)  Shake out the lateral controls system by rotating control wheel up to a maximum of + 10.0 degrees (1.5 units of wheel) and systematically reducing amplitude to zero. Move SPEEDBRAKE handle through the entire range of motion.
6)  With SPEEDBRAKE handle in the DOWN position, adjust spoiler panel protractors to read zero on the following pairs of spoiler panels:
Spoiler Panels 
1 and 12 
2 and 11 
3 and 10 
5 and 8 
6 and 7 

7)  Move the SPEEDBRAKE handle from the down and locked position to the ARMED detent position.  Verify the above spoiler panel angles read zero.
Aviation Partners Boeing
757-200 MAINTENANCE MANUAL SUPPLEMENT  Part II
8)  Move SPEEDBRAKE handle from the armed position to the full UP position.  Verify the spoiler panel angles are with in their required range:
Spoiler Panels  Required Panel Position (degrees)  Measured Panel Position (degrees) 
1 and 12  27.9o to 30.9o 
2 and 11  27.9o to 30.9o 
3 and 10  27.9o to 30.9o 
5 and 8  18.2o to 21.0o 
6 and 7  14.0o to 16.0o 

9)  Check for any irregularities in speedbrake lever forces.  Measure handle force required to move from the ARMED position to the full UP position.  Record the handle force values.
10) Move SPEEDBRAKE handle to the armed position. Measure and record handle forces on the way down. The maximum forces should not exceed 6 pounds.
11) De-pressurize the Left, Center and Right Hydraulic Systems
NOTE: If system fails above test, perform the spoiler rigging adjustment check per
AMM 27-61-00.

12) Return the airplane to normal configuration.
Aviation Partners Boeing
757-200 MAINTENANCE MANUAL SUPPLEMENT  Part II
TASK 27-62-00-000-502
2.  SAC Installation and Light Check
A. General
This test is required to ensure that the Speedbrake Autostow Controller (SAC)
module test and fault lamps are functioning correctly.
NOTE: Airplane system hydraulics is not required for this test

B.  Tool and Equipment Requirements
1) No special tools or equipment required

C. Procedure
1) Make sure the airplane is in this configuration:

a)  Electrical power is on (AMM 24-22-00/201). Note: If external power is used, supply external power per AMM 24-22-00/201, S862-
036. Failure to supply power per this procedure will cause the “Autostow Fault” light to illuminate on the SAC module.
b)  Verify airplane is in GROUND mode.  Landing gear not tilted, air/ground switches not slugged.
2) Verify the following circuit breakers on the P11 circuit breaker panel are closed:
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757-200 MAINTENANCE MANUAL SUPPLEMENT Part II 維護手冊補充(5)