曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

A. Vacuum the work area completely, particularly corners and crevices where soil can become trapped and accumulate.
5. Periodic Maintenance
Performance of this procedure is recommended no less than on a quarterly basis. All the steps for In-Flight Cleaning and Field Maintenance should be performed before the instructions which follow are executed.
WARNING:  PROTECTIVE EYE SHIELDS OR GOGGLES ARE TO BE WORN WHEN CLEANING WITH COMPRESSED AIR. DEBRIS AND/OR HIGH PRESSURE AIR CAN CAUSE SERIOUS EYE INJURY. 
CAUTION:  SMALL PARTS CAN EASILY BE DAMAGED BY HOLDING THE COMPRESSED AIRJET NOZZLE TOO CLOSE. USE BRUSHES CAREFULLY ON DELICATE PARTS. 
TABLE 4001 RECOMMENDED CLEANING AGENTS AND MATERIALS

 Material  Identification  Source 
Air, compressed Brushes, small soft bristled Brushes, non metallic Cloth, Lint Free Compound, corrosion removing Detergent, commercial Desinfectant Isopropyl Alcohol  ----MIL-C-38334 Super Soilax or Electro Sol Lysol Federal Specification TT-I-735  Any approved source Commercially available Commercially available Commercially available Commercially available Commercially available Commercially available Commercially available 

PAGE 4002
25-20-31

REPAIR
1. General
A. In most cases repair consists of replacement of damaged parts.
B. Structural repairs to unit beyond described herein require Bolder Mfg. evaluation. Airline must submit a written description and photograph of damaged area to Bolder Mfg. for repair instruction
C. Airlines may choose to have a qualified and authorized engineering personnel operating under a valid FAA Repair Station to disposition the damage and issue a repairs instruction and obtain proper certification.
D. Periodic inspection for damage and excessive wear of parts is recommended.
E. Except for permissible repairs outlined in this section, repair of detailed parts and components is not considered practical or reliable; certain structural subassemblies are not separately procurable; if damaged, procure next higher assembly. Refer to illustrated parts list for details.
F.  In addition to permissible repairs and replacement of defective parts, certain routine parts replacement shall be conducted at each overhaul, regardless of apparent condition of the parts. All attaching parts (screws, bolts, washers and nuts) if removed during disassembly procedure, shall be routinely replaced at each overhaul, regardless of apparent condition.
G.  See Figure 6001 - Decorative Finish for the appropriate location of decorative materials used on this unit.
2. Metal Parts
A.  Scratches no longer than 1 inch and no deeper than 15% of the material thickness, and dents no deeper than 25% of the material thickness DO NOT require repair and are considered insignificant in structural strength.
B. Remove minor scratches, stains and corrosion by light buffing; however care should be taken not to penetrate the plating.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：COMPONENT MAINTENANCE MANUAL WITH ILLUSTRATED PARTS LIST B757-200 LH RH CLASS DIVIDER(7)