曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

B. In Testing and Fault Isolation, checks and tests required to determine the condition of the unit are contained.
C. Under Disassembly, the disassembly procedures for parts requiring removal to allow for visual inspection and for parts that can be removed and/or replaced are detailed.
D. The Cleaning section lists cleaning agents/materials, as well as instructions for "In-Service Cleaning", "Field Maintenance", and "Periodic Maintenance" of the unit.
E. Methods and criteria for determining the serviceability of individual parts is covered in the Check section.
INTRO PAGE 1

F.  Procedures and materials necessary to repair/replace worn or damaged components and restore the unit to a serviceable condition can be found under Repair.
G.  The Assembly section includes materials required and procedures (consistent with the Disassembly section) for the assembly of the unit.
H.  The Fits and Clearances section lists critical fit clearance tolerances for parts.
J.  The Illustrated Parts List section:
(1)
An itemized breakdown of parts used on the unit which are illustrated as necessary to provide for their identification.

(2)
A numerical index listing all spare parts by part number.

(3)
A vendor list identifying the manufacturer of a part(s) not produced by Bolder MFG, including their name, address and Cage Code.

(4)
A brief introduction on how to use this portion of the manual.

K.  The Removal section provides unit removal instructions from the aircraft.
L.  The Installation section provides instructions for unit installation on the aircraft.
M. The Servicing section provides restoration procedures of the unit.
N.  The Storage section provides storing procedures of the unit while not installed in
the aircraft.

4.  Revisions
A. This manual will be updated in accordance with ATA iSpec 2200.
B. Service Bulletins will be issued separately; however, manual revisions will reflect the impact of applicable Service Bulletins.
 C. Bolder Mfg document control / release system will provide copies of this CMM/IPL to
 all airlines operating the units described herein. All revisions to this manual will be distributed in the same manner.

 

DESCRIPTION AND OPERATION
1.
General

The Class Divider part number BM0901D01M1-501 is on B757-200.
The unit is an integrally-bonded structure fabricated from fiberglass-sandwich panels, and
aluminum extrusions.

2.
Description

A.  General
The Class Divider is used as a Class Divider.

B. Unit Attachments The LH RH Class Divider installation in the aircraft requires two (2) ceiling attachments and two (2) lower attachments. Refer to Figure 2- Class Divider Attachments.
C. Insert Equipment and Provisions.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：COMPONENT MAINTENANCE MANUAL WITH ILLUSTRATED PARTS LIST B757-200 LH RH CLASS DIVIDER(4)