C.  QEC Equipment
(1)
Accessory items installed on the engine are supplied by Boeing in the form of a QEC (Quick Engine Change) equipment kit. Procedures for installing this equipment are contained in this manual.

(2)
QEC kit parts are packaged in a series of sub-kits/tasks identified in the Special Spares Breakdown -Powerplant document issued by Customer Support, Spares. These sub-kit/task numbers are reflected in the figure numbers of 71-00-02 (see paragraph 4).

(3)  
The following installations comprise the QEC kit:

Table 4:
INSTALLATION  DWG NUMBER
ENGINE MOUNTS 310N3020 BRACKETS 332N3900 STARTER 332N3310
INTRODUCTION
Page 4 Jul 15/2009
 
 

(Continued) 
INSTALLATION  DWG NUMBER 
STARTER VALVE  332N3310 
STARTER DUCT  332N3310 
TAI VALVE & DUCT  332N3380/332N3150 
AVM  332N3420 
HYDRAULIC PUMP  332N3120 
FUEL & HYDRAULIC PLUMBING  332N3100 
IDG  332N3240 
IDG PLUMBING  332N3240/332N3150 
OIL MARKER  310N3072 
OIL INSTRUMENTATION  332N3450 
FUEL FLOW XMTR  332N3460 
DE OILER VENT  332N3730 
14TH STAGE SURGE BLEED  332N3750 
OVERBOARD DRAINS  332N3710/332N3150 
HP PILOT CONTROLLER  332N3340 
10TH & 14TH STAGE DUCTING  332N3320 
FIRE/OVERHEAT DETECTOR  332N3500/332N3250 
WIRE HARNESS  332N3220/332N3250 
EXHAUST PLUG & SLEEVE  333N3000 
INLET COWL  330N3010 

4. Instructions for Using Manual
A.  Page Numbering
(1)
Pages are numbered consecutively, starting with 1 in each of the subdivisions of the manual. The subdivision titles appear above the page number of each page.

(2)  
Section 71-00-00 is subdivided into Introduction, Procedures Index, and Numerical Index. Section 71-00-01 is subdivided into individual figures of Accessory Assembly procedures. Section 71-00-02 is subdivided into individual figures of Powerplant Buildup procedures.

B.  Figure and Item Numbers (71-00-01, 71-00-02)
(1)
Figure numbers are assigned to individual segments of buildup in order of accomplishment. Figures in 71-00-02, Powerplant Buildup, utilize a two-part number, the first part of which correlates to the QEC Sub-kit number in which the parts for that figure are supplied.

Exception is Figure 1-1 which is an index figure for 71-00-02.

(2)  
Item numbers are assigned to parts, wherever possible, in order of installation. The part listing with item numbers and nomenclature appear on the text pages immediately following the applicable steps for installation of the parts. Each figure is a complete procedure and contain its individual set of item numbers.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 動力裝置安裝手冊 Powerplant Buildup Manual(6)