E05463
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-11-00
 ALL  ú ú 01 Page 617 ú Sep 20/96

A

757
MAINTENANCE MANUAL

PUSH SEALANT TIGHTLY INTO THE SEAM
Push the First Fillet Seal into the Seam
Figure 608

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-11-00
 ALL  ú ú 01 Page 618 ú Sep 20/96

E05465
A

757
MAINTENANCE MANUAL

DIMENSIONS OF FULL BODIED FILLET SEALS

LOCKBOLT  BOLT
DIMENSIONS OF FILLET SEAL FOR FASTENERS
NOTE:ALL DIMENSIONS ARE IN INCHES.
Dimensions of Fillet Seals
Figure 609

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-11-00
 ALL  ú ú 01 Page 619 ú Sep 20/96

E05466
A

757
MAINTENANCE MANUAL

 (d)  
Cut into the good sealant on each side of the leak with a margin of an inch or more.

 (e)  
Cut the sealant at an angle to make sure the new sealant has an overlap with the remaining sealant (Fig. 605).

 S 116-186
 WARNING:_______DO NOT GET SOLVENTS IN YOUR MOUTH OR EYES, OR ON YOUR SKIN. DO NOT BREATHE THE FUMES FROM SOLVENTS. SOLVENTS ARE HAZARDOUS MATERIALS. REFER TO PRODUCT MATERIAL SAFETY DATA SHEETS (MSDS) AND LOCAL REQUIREMENTS FOR PROPER HANDLING PROCEDURES.
 (2)  Clean the surface with the solvent, Series 93 (AMM 20-30-93/201), or an approved alternative solvent.
 NOTE: Clean an area approximately twice as large as the area
____
 where you will apply the sealant.

 (a)  
Clean the surface with a gauze pad wet with the solvent and dry the surface immediately with a dry gauze pad.

 (b)  
Examine the gauze pad to see if it is dirty.

 (c)  
Continue to clean the surface and dry it until the dry gauze pad is clean when you examine it.

 S 366-070
 CAUTION: MAKE SURE THE PRIMER IS REMOVED IF IT IS NOT HEAT CURED (BAKED
_______ ON) BMS 10-20. THE SEALANT WILL NOT STAY IN PLACE IF THE PRIMER IS NOT HEAT CURED. THIS CAN CAUSE FUEL LEAKAGE.
 (3)  If the surface has a finish layer (topcoat), remove all of the finish from the sealant repair area.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 燃油 CHAPTER 28 - FUEL 1(68)