曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 2)  Let the corrosion resistant finish dry for a minimum of 30
 minutes. 3) Apply a second thin layer like the first layer. 4) Make sure the corrosion resistant finish you applied makes
 an overlap with all adjacent topcoat applied before.
 (b)  For the spray gun procedure (recommended for large areas), do the steps that follow: 1) Set the spray gun to 40 psi air pressure and 5 to 10 psi
 fluid pressure. 2) Apply the corrosion resistant finish with a spray gun on the surface. 3) Let the corrosion resistant finish dry for a minimum of 30
 minutes. 4) Apply the second layer like the first layer. 5) Make sure the corrosion resistant finish you applied makes
 an overlap with all adjacent topcoat applied before.
 S 117-021
 (4)  Clean the equipment and tools after you apply the corrosion resistant finish (topcoat).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-11-00
 ú  ALL  ú
 ú ú  ú 01.101 ú  Page 724Sep 28/02 

A

757
MAINTENANCE MANUAL

 WARNING: DO NOT GET SOLVENTS IN YOUR MOUTH, OR YOUR EYES, OR ON
_______ YOUR SKIN. DO NOT BREATHE THE FUMES FROM SOLVENTS. SOLVENTS ARE HAZARDOUS MATERIALS. REFER TO PRODUCT MATERIAL SAFETY DATA SHEETS (MSDS) AND LOCAL REQUIREMENTS FOR PROPER HANDLING PROCEDURES.
 (a)  
Clean the equipment with solvent, Series 81 (AMM 20-30-81/201, SOPM 20-30-81) immediately after use.

 (b)  
Soak the brushes in solvent, Series 81 (AMM 20-30-81/201, SOPM 20-30-81) immediately after use.

 NOTE: Discard the brushes when the bristles become rigid.
____
 S 627-059
 (5) Cure the corrosion resistant finish. ~.............................................................................. | Table 702 | | Corrosion Resistant Finish Cure Time | ................................................................................ | CORROSION | CURE TIME | CURE TIME | CURE TIME | CURE TIME | | RESISTANT | BEFORE | BEFORE | BEFORE | BEFORE | | FINISH | FUEL EXPOSURE | TRAFFIC | ASSEMBLY | SEALING | | (BY MFGR.)| *[1] | | *[1] | *[2] | ................................................................................
 |Bostik West| 12 hours at  | 12 hours at  | 12 hours at  | Fig. 702  |
 |(BMS 10-20)| 65°F or above  | 65°F or above | 65°F or above  | *[3]  |
 |Type II)  | or Fig. 702  | or Fig. 702  | or Fig. 702  |  |
 |  | *[3]  | *[3]  | *[3]  |  |
 |  |  |  |  |  |
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 燃油 CHAPTER 28 - FUEL 1(109)