4.
Use individual FWD or AFT controls to adjust the platform to the necessary tilt being careful to avoid patient to aircraft contact.

4.12.17.3 Load Third Patient.
1. Position the patient under the lower litter plat-form.
2.
Position and fasten the patient restraints.

3.
Once litter(s) are positioned, place one or all four cabin medical control panel EMER-GENCY STOP switches -STOP.

4.12.17.4 Unload the Third Patient.
1.
Unfasten the patient restraints.

2.
Reverse the loading procedure and carefully unload the patient.

4.12.17.5 Unload the Second Patient.
1.
Use individual FWD or AFT controls to level the platform as much as possible.

2.
Simultaneously  press the LOWER PLAT-FORM, FWD, and AFT controls to the DOWN position.

3.
As the platform approaches the .oor position, release the switches. The platform stops.

4.
Reverse the loading procedure and slide the lit-ter platform out of the aircraft.

4.12.17.6 Unload the First Patient.
1.
Use individual FWD or AFT controls to level the platform as much as possible.

2.
Simultaneously  press the UPPER PLAT-FORM, FWD, and AFT controls to the DOWN position. The upper litter platform moves down.

3.
As the upper platform approaches the lower platform, release the switches. The platform stops.

4.
Reverse the loading procedure and slide the lit-ter platform out of the aircraft.

4.12.18 Ambulatory (Seated) Patient Con.gura-tion. The upper platform of each medical station is used for seating up to three ambulatory patients. The upper half of the platform is raised to provide a backrest for the pa-tients. Up to a maximum of six ambulatory patients can be carried on the platforms. Two additional ambulatory pa-tients can be seated on the aft troop seats.
NOTE
Use of the MEDEVAC ambulatory con.gu-ration for transport of personnel other then patients or essential medical personnel is prohibited.
1.
Simultaneously press and hold the  LOWER PLATFORM, FWD, and AFT controls to the DOWN position. The lower litter platform moves down. Hold the switches until the plat-form stops moving. The platform stops about 3 inches above the .oor.

2.
Simultaneously  press and hold the UPPER PLATFORM, FWD, and AFT controls to the DOWN position until the upper litter platform moves down to just above the lower platform.

To prevent damage to the platforms, stop the upper platform motion prior to reach-ing the lower platform.
3.
Unlock and release the forward and aft seat tracks .ttings from the seat tracks in the over-head lighting .xture (Figure 4-26) by pulling out, with a .rm pull, on the circular clip at the end of the seat track .tting.

4.
Fold down the ambulatory seats from the top of the compartment and extend the telescoping guide tubes to the top of the upper litter plat-form.

5.
Remove  the quick release pins from their stowed position in the seat pan and install them in the telescoping guide tubes next to the head-rest.

6.
Lock the seat track .ttings into the tracks on the litter platform.

7.
Rotate the seat pan down and headrest up into position.

4.12.19 Stow Ambulatory Patient Seats.
1.
Rotate the seat pan up and headrest down to the stowed positions.

2.
Locate the seat track .ttings holding the seat legs to the upper litter platform and pull up on the circular clip at the end of the seat track .tting.

3.
Slide each seat rack .tting into the open slot and remove it from the upper litter platform.

4.
Remove the quick release pins from the tele-scoping guide tubes next to the head rest and install them in their stowed position in the seat pan.
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：UH-60Q 直升機技術(shù)手冊 直升機操作手冊 1(154)