DISCHARGE 
PORT  SCREEN 
SQUIB 
SEE  C 
DISCHARGE ASSEMBLY 
ELECTRICAL 
B  CONNECTOR  C 

Engine Fire Extinguishing System Component Location
Figure 501

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 26-21-00
 ALL  ú ú 03 Page 502 ú Sep 20/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
 D.
E.
F.

A
757
MAINTENANCE MANUAL

Prepare for Test
 S 865-001
 (1) Supply electrical power (AMM 24-22-00/201).Do a test of the Extinguisher Bottle Pressure Switch
 S 825-256
 CAUTION: IF THE HEX KEY IS ROTATED MORE THAN 1/4 TURN, DAMAGE TO THE
_______ SWITCH MAY OCCUR.
 (1)  On engine fire extinguisher bottle number 1, turn and hold the ground test hex key 1/4 turn counterclockwise.
 (a)  
Make sure the yellow ENG BTL 1 DISCH light on the ENGINE FIRE Control Panel, P8, comes on.

 (b)  
Make sure the EICAS message, ENG BTL 1, shows on the top display.

 S 865-005
 (2)  Release the ground test hex key.
 (a)  
Make sure the yellow ENG BTL 1 DISCH light goes off.

 (b)  
Make sure the EICAS message, ENG BTL 1, does not show on the top display.

 S 825-007
 (3)  On engine fire extinguisher bottle number 2, turn and hold the ground test hex key counterclockwise.
 (a)  
Make sure the yellow ENG BTL 2 DISCH light on the ENGINE FIRE Control Panel, P8, comes on.

 (b)  
Make sure the EICAS message, ENG BTL 2, shows on the top display.

 S 865-010
 (4)  Release the ground test hex key.
 (a)  
Make sure the yellow ENG BTL 2 DISCH light goes off.

 (b)  
Make sure the EICAS message, ENG BTL 2, does not show on the

 top display.Do a test of the Extinguisher Bottle Squib Test Circuit
 S 715-012
 (1)  On the SQUIB TEST Control Panel, P61, push and hold the TEST switch.
 (a)  Make sure the green ENG L (1 and 2) and ENG R (1 and 2) squib test lights come on.
 S 865-094
 (2)  
Release the TEST switch.

 (a)  Make sure the green ENG L (1 and 2) and ENG R (1 and 2) squib test lights go off.

 (3)  
Remove electrical power if it is not necessary (AMM 24-22-00/201).

 S 865-017
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 26-21-00
 ALL  ú ú 01 Page 503 ú Sep 28/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757 MAINTENANCE MANUAL
 TASK 26-21-00-735-201
 3. System Test
___________
 A. General
 (1)  The engine fire extinguishing system has two identical fire bottles located in the forward of the aft cargo compartment, an engine fire control panel, and a squib test panel. The extinguishing plumbing is connected to the left and right engine, which lets each engine receive extinguishing agent from either bottle. Each engine has an independently operated fire extinguishing system.
 WARNING: DO NOT TOUCH THE SQUIB BEFORE YOU DO THE PROCEDURES FOR DEVICES
_______ THAT ARE SENSITIVE TO ELECTROSTATIC DISCHARGE. ELECTROSTATIC DISCHARGE CAN CAUSE THE FIRE BOTTLE TO RELEASE ITS CONTENTS SUDDENLY AND CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 (2)  Before you touch the squib, do the procedure for devices that are sensitive to electrostatic discharge (AMM 20-41-01/201).
 B. Equipment
 (1)  Electrical Test Equipment - Bottle Squib, Fire
 Extinguisher System - A26001-165

 NOTE: The A26001 test boxes do not include the test adapters.
____ Refer to the A26001 drawing for the required test adapter cables.
 (2)  
Squib Protective Covers
 M83723/60-112-AN or AC
 M83723/60-110-AN or AC
 M83723/60-210-AN or AC
 M83723/60-108-AN or AC

 (3)  
Voltmeter - 28 vdc

 (4)  
Resistor - 10 kohms or greater
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 防火 FIRE PROTECTION 2(11)