E.  Procedure
 S 046-012-N00
 WARNING: DO THE DEACTIVATION PROCEDURE TO PREVENT THE OPERATION OF THE
_______ THRUST REVERSER. THE ACCIDENTAL OPERATION OF THE THRUST REVERSER CAN CAUSE INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 80-11-01
 ALL  ú ú N01 Page 601 ú Feb 10/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / PW4000 SERIES /747-400 / ENGINES /MAINTENANCE MANUAL ////////////////////////
VALVE START 
SEE  A 
OIL FILL PLUG 
MAIN GEARBOX 
FWD  STARTER A MCD HOUSING SEE  B  CLAMP ATTACH-DETACH QUICK 
Starter Inspection Figure 601 B OVERFLOW PLUGPROBE DETECTOR (MCD) MAGNETIC CHIP 

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 80-11-01
 ALL  ú ú N01 Page 602 ú Jun 10/88
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
(1)  
Do the deactivation procedure for the thrust reverser for ground maintenance (AMM 78-31-00/201).

 S 016-013-N00

 (2)  
Open the right fan cowl panel (AMM 71-11-04/201).

 S 016-014-N00

 (3)  
Open the right core cowel panel (AMM 71-11-06/201).

 S 016-010-N00
 WARNING: OBEY THE INSTRUCTIONS IN THE PROCEDURE TO OPEN THE THRUST
_______ REVERSERS. IF YOU DO NOT OBEY THE INSTRUCTIONS, INJURIES TO PERSONS AND DAMAGE TO EQUIPMENT CAN OCCUR.
 (4)  
Open the right thrust reverser (AMM 78-31-00/201).

 S 226-003-N00

 (5)  
Examine the probe on the magnetic chip detector (MCD) for metal pieces:

 (a)  Remove the MCD probe and the packing from the MCD housing on
 the starter.

 NOTE: The MCD housing has a two part bottom which lets
____ you remove the MCD probe without oil leakage. A seal with a spring closes the opening while you remove the MCD probe.
 1) Discard the packing from the MCD probe.
 (b)  Examine the MCD probe for a large quantity of metal pieces
 (pins, lockwires, metal chips from the casting, etc.).

 NOTE: You can see a small quantity of metal particles if the
____ starter has satisfactory worn areas (Fig. 602).
 1) Replace the starter if metal pieces are more than 0.1 inch
 (2.5 mm) in its largest dimension (AMM 80-11-01/401).
 WARNING: DO NOT GET THE METHYL ETHYL KETONE (MEK) IN YOUR
_______ MOUTH OR EYES, OR ON YOUR SKIN. DO NOT BREATHE THE FUMES FROM THE MEK. PUT ON A PROTECTIVE SPLASH GOGGLE AND GLOVES WHEN YOU USE THE MEK. KEEP THE MEK AWAY FROM SPARKS, FLAME, AND HEAT. THE MEK IS A POISONOUS AND FLAMMABLE SOLVENT WHICH CAN CAUSE INJURY OR DAMAGE.
 2) If the metal pieces are less than 0.1 inch (2.5 mm) in its largest dimension, clean the MCD probe with the solvent. 3) Make the MCD probe dry with a clean cloth.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 80-11-01
 ALL  ú ú N01 Page 603 ú Jun 18/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / PW4000 SERIES /747-400 / ENGINES/MAINTENANCE MANUAL ////////////////////////
(c)  
Install the MCD probe with the new packing:

 1)  Tighten the probe to 8-24 pound-inches (0.9-2.7 newton-meters).

 (d)  
Install a lockwire on the MCD probe.

 S 216-006-N00
 (6)  Examine the outer area of the starter for oil leakage.
 (a)  
If a large quantity of oil leakage is around the starter housing, replace the starter (AMM 80-11-01/401).

 (b)  
If a large quantity of oil leakage is around the fill plug or the overflow plug, remove the applicable plug. 1) Examine the packing of the removed plug for damage. 2) If the packing is damaged, replace the packing. 3) Install the applicable plug with the new packing.

 a)  Tighten the fill plug to 40-70 pound-inches (4.5-7.9 newton-meters).
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 起動 STARTING(12)