K79534
5C8  Aft Cabin Attendants' Panel 
Oct 20/88  Figure 1 (Sheet 3)  31-15-21 
Page 3 

FLIGHT DATA RECORDER SYSTEM - DESCRIPTION AND OPERATION
EFFECTIVITY
Airplanes with Sundstrand Universal Flight Data Recorder (UFDR)
1. General (Fig. 1)
A.  The universal flight data recorder system digitally records, on magnetic tape, selected signals received during the last 25 hours of airplane operation. The signals are received from other airplane systems and sensors.
B.  The system consists of a universal flight data recorder (UFDR), accelerometer, trip and date encoder, and the flight recorder TEST-NORMAL switch and OFF light on the FLIGHT RECORDER AND MACH AIRSPEED WARNING module.
C.  The recorder is capable of recording: -1000 to 50,000 feet altitude, 100 to 450 knots airspeed, 0 thru 360 degrees heading, -3 to +6g's of vertical acceleration (on airplanes with 3-axis accelerometers longitudinal accelerations are also recorded), and discrete signals for recording an ATC event.
D.  An underwater locator beacon is installed on the UFDR front panel. The beacon is a battery powered unit, which activates immediately upon immersion in water.
E.  The accelerometer is installed near the airplane center of gravity on the aft side of the left main wheel well forward bulkhead at station 663. Access to the accelerometer is through the wheel well.
F.  The trip and date encoder and FLIGHT RECORDER AND MACH AIRSPEED WARNING MODULE are located on the aft overhead panel P5 in the control cabin.
G.  All input data are FAA mandatory parameters. Data are received in analog and discrete format. These data are recorded and stored in a crash proof container within the UFDR.
H.  The system is turned on automatically when the airplane is in flight, or on the ground when an engine is operating. The system may also be turned on by the TEST-NORMAL switch on the flight recorder control panel.
2.  Universal Flight Data Recorder (UFDR) (Fig. 1)
A.  The UFDR is installed above the ceiling panels at station 947, WL290, LBL10.
B.  The UFDR records the output data for the last 25 hours of airplane operation. Data is stored on the 1/4-inch wide, 450 feet long Kapton magnetic tape. The tape and transport are located in a crash-proof container within the UFDR. The unit weighs 28 lbs and is housed in a 1/2 ATR long container.
5C8
Jun 20/88 31-24-0 Page 1

K80041
Flight Recorder System Component Location  5C8 
31-24-0  Figure 1  Feb 20/85 
Page 2 
BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. 

C.  The UFDR front panel contains a BITE indicator, test connector and an underwater locator beacon. The BITE indicator is yellow when the UFDR is faulty or power to the unit is off, black when the UFDR is operating properly. The test recorder connector allows connecting a tester to the recorder. The underwater locator beacon is a battery operated unit which transmits an ultrasonic signal when the unit is immersed in water.
D.  The tape transport is a coplanar, peripheral belt driven device which contains tape, reel drive belt, two reel hubs, capstan/fly wheel, two belt idlers, tape guides and EOT/BOT (end of tape/beginning tape) sensors. Also, there are two interleaved four-channel erase heads, two interleaved four-channel read/write heads, and the primary drive belt. The primary drive belt passes through a hole in the wall of the transport to connect the drive motor with the capstan/fly wheel. A second hole is used by the wiring for the heads and tape sensors. The two holes are each lined with a feedthru, which become swollen and plug the holes in the event of fire.
E.  The stepper drive motor, mounted outside of the crash-proof container, operates in a semi-slewing mode to drive the capstan/flywheel. The capstan/flywheel then drives a belt which passes over the two wheel hubs and the belt idlers. The EOT/BOT sensor switches the drive motor direction and switches tape tracks at each end of the tape. The read/write heads and the erase heads produce eight sequential tracks of recording. Tape speed is 6 inches per second with the stepper motor running either continuously or incrementally which gives a net tape speed of 0.48 inches per second.
F.  The UFDR tape transport is located inside a crash proof container. The container consists of two halves with a steel outer shell and a fire insulation and fiberglass liner. A gasket is used between the two halves. Expanded material lines the belt and wire entry holes. The container is mounted to the front panel/chassis assembly with vibration isolators.
3.  Accelerometer (Fig. 1)
A.  The accelerometer is a self-contained sealed unit mounted on the aft side of the forward wall of the right wheel well at station 663, LBL50, WL194 and is accessible through the wheel well. On airplanes with single-axis accelerometer the accelerometer's sensitive axis is oriented to detect vertical acceleration forces with a range of -3 to +6 g's. On airplanes with 3-axis accelerometer, longitudinal acceleration forces are also detected. The unit supplies the recorder with a 400-Hz amplitude modulated signal which is a function of the acceleration of the airplane. A 26-volt, 400 Hz ac excitation voltage is provided to the accelerometer from the UFDR.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737 AMM 飛機維護手冊 儀表和面板(6)