F. Return airplane to normal.
G. De-energize load control center P18.
H. Remove electrical power if no longer required.
5C8
Jun 20/88 BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. 31-24-81 Page 401
Flight Recorder Accelerometer Installation 535
31-24-81 Figure 401 Feb 15/72
Page 402
BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.
UNDERWATER LOCATOR BEACON UNIT - MAINTENANCE PRACTICES
1. General
A. The underwater locator beacon unit, if installed, is mounted on the access door of the flight recorder located above the ceiling panels at station 947. Access to the flight recorder is by opening the aft lower ceiling panel No. 2.
2. Underwater Locator Beacon Unit Removal/Installation (Fig. 202)
A. Gain access to flight recorder.
B. Remove Underwater Locator Beacon Unit (airplanes with analog flight recorder).
(1)
Open flight recorder access door.
(2)
Remove locknuts and washers from retainer straps holding underwater locator beacon unit.
(3)
Remove underwater locator beacon unit. Retain straps locknuts and washers.
C. Remove Underwater Locator Beacon Unit (airplanes with Sundstrand UFDR).
(1)
Remove four screws and two mounts from the front panel of the UFDR. Remove underwater locator beacon unit.
(2)
Retain screws and mounts.
D. Remove Underwater locator Beacon Unit (airplanes with Fairchild DFR).
(1)
Remove four screws and lockwashers to separate the cover plate from cradle assembly. Pull underwater locator beacon unit from the cradle assembly.
(2)
Retain cradle assembly, screws, and lockwashers.
E. Install Underwater Locator Beacon Unit (airplanes with analog flight recorder).
(1)
Position underwater locator beacon unit and retainer straps on flight recorder door.
(2)
Install clamps with locknut and washers.
(3)
Rotate underwater locator beacon unit so that battery replacement date decal on beacon unit is visible.
(4)
Tighten locknuts.
(5)
Check that water switch on ULB end is free from dirt, grease or moisture. Wipe clean with freon solvent, if required.
(6)
Close flight recorder door.
F. Install Underwater Locator Beacon Unit (airplanes with Sundstrand UFDR).
(1)
Place underwater locator beacon unit between two mounts.
(2)
Rotate beacon so that battery replacement date decal is visible.
(3)
Secure mounts to front panel of UFDR with four screws.
(4)
Check that water switch on ULB end is free from dirt, grease or moisture. Wipe clean with freon solvent, if required.
501
Oct 20/85 BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. 31-24-111 Page 201
Underwater Locator Beacon Unit Battery Replacement 556
31-24-111 Figure 202 Oct 20/85
Page 202
BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.
G. Install Underwater Locator Beacon Unit (airplanes with Fairchild DFR).
(1)
Insert Underwater Locator Beacon in DFR mounting cradle with water switch facing downward.
(2)
Rotate beacon so that battery replacement date decal is visible.
(3)
Secure cradle assembly on the cover plate with four sets of screws and lockwashers.
(4)
Check that water switch on ULB end is free from dirt, grease or moisture. Wipe clean with freon solvent, if required.
H. Test Underwater Locator Beacon Unit for operation as described in par. 4.
3. ULB P/N N15F210 Only - Underwater Locator Beacon Unit Battery Replacement (Fig. 201)
CAUTION: DO NOT DISASSEMBLE ULB P/N DK100. NO BATTERY MAINTENANCE IS REQUIRED FOR THE DK100 ULB. AT OR NEAR THE EXPIRATION DATE PRINTED ON THE CASE, RETURN THE ULB TO THE MANUFACTURER FOR SERVICE.
A. Equipment and Material
(1)
Spanner Wrench - DuKane 810-325, or equivalent
(2)
O-Ring - DuKane 810-342, or equivalent
(3)
Lubricant - DuKane 810-346, or equivalent
(4)
Split radiator hose, 1-1/4-inch diameter, 5 inches in length
B. Replace Battery
(1)
Remove underwater locator beacon unit from flight recorder door.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737 AMM 飛機維護手冊 儀表和面板(24)
