545 
22-11-0  Aug 01/74 
Page 114 
BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. 

TROUBLE  PROBABLE CAUSE  ISOLATION PROCEDURE  REMEDY 
Pitch axis stabilization is poor (Vertical gyro known good) Pitch channel does not respond to control wheel steering inputs Pitch control wheel steering oversensitive or erratic  Pitch channel Pitch channel, CADC or control wheel steering transducer Control column detent breakout forces out of tolerance (pitch force transducers misrigged)  Conduct self-test of pitch channel. If pitch channel fails self-test pitch channel is faulty Conduct pitch channel self-test. If pitch channel fails self-test 2 or more, push on control column and check for 1.3 to 2.4-v ac at TP-13 on pitch channel. If voltage, pitch channel is faulty. If no voltage, CADC is faulty. If pitch channel ok, control wheel steering transducer is faulty Engage autopilot. Apply 14-pound push then pull to control column while monitoring voltage at pitch channel TP-13. Check voltage is between 1.3 and 2.4 VAC If voltage incorrect disconnect captain's force transducer connector. Apply 28-pound push then pull to control column while monitoring voltage at pitch channel TP-13, Check voltage is between 1.3 and 2.4 VAC If voltage incorrect repeat above procedure with captains force transducer connected and first officers force transducer disconnected  Replace pitch channel Replace pitch channel Adjust or replace pitch CWS transducer (Ref 22-11-91, Pitch Control Wheel Steering Force Transducer) Voltage erratic. Replace pitch channel If voltage correct replace first officers pitch CWS force transducer (Ref 22-11-91) If voltage correct replace captain is pitch CWS force transducer (Ref 22-11-91) 

500 
Feb 15/77  22-11-0 
Page 115 
BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. 

500 
22-11-0 Page 116  BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.  Jun 20/85 

C89480 C89388
500 
Oct 20/93  BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.  22-11-0 Page 116A 

500 
22-11-0 Page 116B  BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.  Oct 20/93 

TROUBLE  PROBABLE CAUSE  ISOLATION PROCEDURE  REMEDY 
Glide slope annunciator lights do not indicate armed or engaged modes Mode selector switch does not return to MAN when CWS used on glide slope  Autopilot accessory box Pitch channel or roll channel  Replace autopilot accessory box and test lights (Refer to Test Approach Mode in Adjustment/Test). If fault not corrected, see Autopilot Annunciator Trouble Shooting Chart Replace pitch channel and test system. (Refer to Test AUTO/APP Mode Control in Adjustment/Test.) If fault is not corrected, roll channel is faulty  Replace autopilot accessory box Replace pitch channel. Replace roll channel 

542 
Feb 15/77  22-11-0 
Page 116C/116D 
BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. 

C. Stabilizer Trim Trouble Shooting Chart D. Roll Channel Engage Trouble Shooting Chart E. Roll Channel Operation Trouble Shooting Chart
TROUBLE  PROBABLE CAUSE  ISOLATION PROCEDURE  REMEDY 
Stabilizer trim warning light illuminated (flight fault) (interlocks ok) Stabilizer drives in only one direction  Pitch channel or stabilizer trim servo Elevator power control unit (PCU) Pitch channel or stabilizer trim servo Stabilizer trim limit switches  Replace pitch channel and engage pitch channel. Close autopilot stabilizer trim circuit breakers. Move control column forward or back and neutralize. Stabilizer should drive to maximum nose up or nose down position. If stabilizer does not move, stabilizer trim servo is faulty Replace elevator PCU and check for sufficient actuator force output with autopilot input per overhaul manual instructions Repeat above isolation procedure Manually trim stabilizer to 3 units of trim. Open autopilot trim cutout switch. Check continuity through S144 and S145 limit switches. No continuity, limit switch is faulty. NOTE: Terminals 2 and 5 are stowed.  Replace pitch channel. Replace autopilot stabilizer trim servo (Ref 22-11-81, Autopilot Stabilizer Trim Servo) Replace elevator PCU Replace pitch channel. Replace autopilot stabilizer trim servo (Ref 22-11-81, Autopilot Stabilizer Trim Servo) Replace stabilizer trim limit switch 

500 
Aug 15/77  22-11-0 
Page 117 
BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. 

TROUBLE  PROBABLE CAUSE  ISOLATION PROCEDURE  REMEDY 
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737 AMM 飛機維護手冊 AUTO FLIGHT 自動飛行 1(37)