∞∞80-00-00∞∞∞∞∞∞∞∞∞∞Page 219
EEFF : ALL E
E E Aug 01/05
E E
ECES E
F 『
E C F M E
E E
E 56 E
E E
INTENTIONALLY BLANK
F 『R E E ∞∞80-00-00∞∞∞∞∞∞∞∞∞∞Page 220
E E Aug 01/05 E E ECES
E
F 『
E C F M E
E E
E 56 E
E E
B. Do an engine automatic start procedure (Ref. AMM TASK 71-00-00-710-003).
F 『 EEFF : ALL E ∞∞80-00-00∞∞∞∞∞∞∞∞∞∞Page 221
E E Aug 01/99 E E ECES
E
F 『
E C F M E
E E
E 56 E
E E
PNEUMATIC STARTER AND VALVE SYSTEM - FAULT ISOLATION PROCEDURES
_______________________________________________________________
TASK 80-11-00-810-801
Failure of the Starter Shutoff Valve Switch on Engine 1
1. Possible Causes
_______________
R - starter shutoff valve R - ECU (4000KS) R
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 73-21-50-000-042 Removal of the HJ9 Harness AMM 73-21-50-000-043 Removal of the HJ10 Harness AMM 73-21-50-210-001 Visual Inspection of the Wiring Harness AMM 73-21-50-400-042 Installation of the HJ9 Harness AMM 73-21-50-400-043 Installation of the HJ10 Harness AMM 73-21-60-000-001 Removal of the Electronic Control Unit (ECU) AMM 73-21-60-400-001 Installation of the Electronic Control Unit (ECU) AMM 73-29-00-710-040 Operational Test of the FADEC on the Ground (with
Engine non Motoring)
AMM 80-11-20-000-003 Removal of the Starter Shutoff Valve
AMM 80-11-20-400-003 Installation of the Starter Shutoff Valve
3. Fault Confirmation
__________________
A. Do the operational test of the FADEC 1A on the ground (with engine non motoring) (Ref. AMM TASK 73-29-00-710-040).
4. Fault Isolation
_______________
A. This failure message is generated if channel A and B switches of the R starter shutoff valve disagree.
(1) If the failure message SAV (SW) J9/J10, ECU* is not confirmed: R
R (a) No maintenance action is required.
(2) If the failure message SAV (SW) J9/J10, ECU* is not confirmed but is repetitive:
- replace the starter shutoff valve (Ref. AMM TASK 80-11-20-000-003) and (Ref. AMM TASK 80-11-20-400-003).
F 『 EEFF : ALL E ∞∞80-11-00∞∞∞∞∞∞∞∞∞∞Page 201
E E Aug 01/99 E E ECES
E F 『 EEFF : ALL E ∞∞80-11-00∞∞∞∞∞∞∞∞∞∞Page 202
F 『
E C F M E
E E
E 56 E
E E
R R R (a) If the failure continues during the subsequent flights: - replace the ECU (4000KS) (Ref. AMM TASK 73-21-60-000-001) and (Ref. AMM TASK 73-21-60-400-001).
R (b) If the failure continues during the subsequent flights: - replace the harness HJ9 (channel A) (Ref. AMM TASK 73-21-50-000-042) and (Ref. AMM TASK 73-21-50-400-042). - replace the harness HJ10 (channel B) (Ref. AMM TASK 73-21-50-000-043) and (Ref. AMM TASK 73-21-50-400-043).
R (3) If the failure message SAV (SW) J9/J10, ECU* is confirmed: - disconnect the harnesses HJ9 (channel A) and HJ10 (channel B) from the starter shutoff valve.
R (a) Visually examine the receptacles and the connectors for damaged pins or contamination (Ref. AMM TASK 73-21-50-210-001).
R 1_ If damage is found: - repair or replace as required.
R R R 2_ If no damage is found:- do an electrical resistance test through the starter shutoff valve for both channels between: . pin 1 and pin 2 (15 to 60 ohms) . pin 1 and pin 5 (> 10 megohms) . pin 1 and the ground (> 10 megohms).
R R R a_ If the resistance values are out of the specified limits:- replace the starter shutoff valve (Ref. AMM TASK 80-11-20-000-003) and (Ref. AMM TASK 80-11-20-400-003).
R R R b_ If the resistance values are in the specified limits:- connect the harnesses HJ9 (channel A) and HJ10 (channel B) to the starter shutoff valve and continue the trouble shooting procedure.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 STARTING 起動(10)
