- at N2 > 50 percent the starter shutoff valve closes and ignition system 1(2) is no more excited

 3 Place the ENG/MODE/CRANK/NORM/IGN/START selector switch in
_
 NORM position :

 - the ENG page disappears
 4 Place ENG/MAN START pushbutton switch in OFF position
_ NOTE : If you place the ENG/MODE/CRANK/NORM/IGN/START selector
____ switch in : NORM position after engine 1 starting, then in IGN/START position prior to engine 2 starting : continuous ignition is automatically selected for engine 1.
 F 『 EEFF : ALL E Page 774-31-00
 E E Aug 01/05 E E ECES E E 56-5B E

 F  『
 E  C F M  E
 E  E

 E E With the MASTER control switch in ON position or ENG/MAN START pushbutton switch set to ON and the ENG/MODE/CRANK/NORM/IGN/START selector switch in NORM position : there is not effect on the corresponding engine (if it is not running).

 (3) Alternative start interruption
 You interrupt the alternative start if :

 - you release ENG/MAN START pushbutton switch with the MASTER control switch in OFF position

 - you place the MASTER control switch back in OFF position if it was to ON.

 C. Continuous Ignition
 (1) Manual selection When engines are running on ground or in flight : place the ENG/MODE/CRANK/NORM/IGN/START selector switch in IGN/START position.

 (2) Automatic selection
 For an in-flight restarting when :

 - you select engine anti-ice (ECS data).

 - the EIU fails (except during cranking).

 - flameout is detected

 - ignition delay during start During an automatic start, as soon as N2 is higher than 16 percent, the start must occur in the 15 to 20 seconds that follow (depending on the ambient temperature). If this time is greater and the ECU does not detect a difference of the EGT of at least 42 DEG.C, the ECU controls a dry motoring cycle followed by a selection of the continuous ignition.

 D. Failure Indicating
 An ECAM message is displayed:

 - in case of no light off detection (amber caution)
 or

 - in case of ignition system failure or power supply not available.

 F 『 EEFF : ALL E Page 874-31-00
 E E May 01/05 E E ECES E

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

 IGNITION STARTING AND CONTINUOUS RELIGHT - DEACTIVATION/REACTIVATION
____________________________________________________________________ TASK 74-31-00-040-001 Check of the Ignition System
 1. Reason for the Job
__________________
 Refer to the MMEL TASK: 74-31-03
 Ignition And Starting
 IGN FAULT warning

 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific warning notice
 B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
74-00-00-710-043 Operational Test of the Ignition System
 3. Job Set-up
__________ Subtask 74-31-00-869-052
 A. Not Applicable
 4. Procedure
_________ Subtask 74-31-00-710-051
 A. Do the operational test of the ignition system (Ref. TASK 74-00-00-710-043) and make sure that the ignition system is operative.
 F 『 EEFF : ALL E Page 40174-31-00
 E E Feb 01/98 E E ECES E Subtask 74-31-00-941-051

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E

 B. Safety Precautions
 (1) Put a warning notice in the cockpit to tell persons that the ignition warning system does not operate.

 (2) Make an entry in the log book.

 F 『 EEFF : ALL E Page 40274-31-00
 E E Feb 01/98 E E ECES E

 F 『
 E C F M E
 E E
 E 56-5B E
 E E

 TASK 74-31-00-040-002
 Check of Ignition Fault Warning
 1. Reason for the Job
__________________
 Refer to the MMEL TASK: 74-31-02
 Ignition
 Selected Igniter Indication On ECAM LD
 (FAA Only)

 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM IGNITION 點火(42)