(2)
Open the APU access doors 315AL and 316AR (Ref. TASK 52-41-00-010-001).
(3)
Set the LIGHT control switch 11LJ to the on position
4. Procedure
_________ (Ref. Fig. 201/TASK 49-42-51-991-001) Subtask 49-42-51-020-054
A. Removal of the Starter Motor (8KA) (Original Configuration P/N:
2000866-1/-2).
(1) Carefully pull back the rubber sleeves (13) to get access to the starter motor (8KA) electrical connectors.
CAUTION : MAKE MATCH MARKS ON ALL THE ELECTRICAL WIRES BEFORE YOU
_______ DISCONNECT THEM. INCORRECT CONNECTION OF WIRES WILL CAUSE DAMAGE TO EQUIPMENT.
(2)
Remove the locknuts (2) and the washers (4).
(3)
Remove the electrical leads (5), (6) and (25) from the starter motor (8).
(4)
Remove the V-clamp (7) which attaches the starter motor (8) to the accessory drive gearbox.
(5)
Remove the starter motor (8KA) (8).
(6)
Remove and discard the packing (9) from the starter motor (8).
(7)
Put the blanking plugs on the gearbox starter motor mount flange. Subtask 49-42-51-020-056
B.
Removal of the Starter Motor (8KA) (Optional Configuration P/N:
2704506-1/-2).
(1) Slide back the single rubber cover (24) to get access to the starter motor lead terminals.
CAUTION : MAKE MATCH MARKS ON ALL THE ELECTRICAL WIRES BEFORE YOU
_______ DISCONNECT THEM. INCORRECT CONNECTION OF WIRES WILL CAUSE DAMAGE TO EQUIPMENT.
(2)
Remove the self-lock nuts (17) and (21) and the washers (18) and (20).
(3)
Remove the leads (16) and (22) and the monitor lead (19) from the terminals.
(4)
Remove the V-clamp (7) which attaches the starter motor to the accessory drive gearbox.
(5)
Remove the starter motor (8KA) (14).
(6)
Remove and discard the packing (9) from the starter motor (8KA) (14).
(7)
Put the blanking plugs on the gearbox starter motor mount flange.
Starter Motor
Figure 201/TASK 49-42-51-991-001
CES
TASK 49-42-51-100-002
Cleaning of the Starter Motor (8KA) (GTCP 36-300)
WARNING : USE SOLVENTS/CLEANING AGENTS, SEALANTS AND OTHER SPECIAL MATERIALS
_______ ONLY WITH A GOOD SUPPLY OF AIR. OBEY THE MANUFACTURERS INSTRUCTIONS. PUT ON PROTECTIVE CLOTHING. DO NOT GET THEM IN YOUR MOUTH. DO NOT SMOKE. DO NOT BREATHE THE GAS. THESE MATERIALS ARE POISONOUS, FLAMMABLE AND SKIN IRRITANT. GET MEDICAL HELP IF YOUR SKIN OR EYES BECOME IRRITATED.
WARNING : DO NOT GET THE COMPOUND ON YOUR SKIN.
_______ IF YOU DO:
-RUB IT OFF IMMEDIATELY WITH A CLEAN CLOTH
-WASH THE SKIN WITH SOAP AND RINSE WITH CLEAN WATER.
WARNING : DO NOT GET THE FLUID ON YOUR SKIN OR IN YOUR EYES. IF YOU DO:
_______
-FLUSH IT AWAY WITH CLEAN WATER
-GET MEDICAL AID.
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s)
B. Consumable Materials
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 11-002 USA MIL-PRF-680 DRY CLEANING SOLVENT (VARSOL/WHITE SPIRIT) (Ref. 20-31-00)
Material No. 11-004 USA MIL-T-81533 1.1.1TRICHLOROETHANE (METHYL CHLOROFORM) (Ref. 20-31-00)
C. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied from the External Power 29-00-00-864-001 Put the Related Hydraulic System in the Depressurized
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM 機載輔助動力 AIRBORNE AUXILIARY POWER4(94)
