3. Job Set-up__________
Subtask 49-31-00-860-054
A. Aircraft Maintenance Configuration
(1)
Energize the aircraft electrical circuits
(Ref. TASK 24-41-00-861-002).
(2)
Do the EIS start procedure (Upper ECAM DU and lower ECAM DU only) (Ref. TASK 31-60-00-860-001).
(3)
On the FUEL overhead panel 40VU, make sure that all L TK PUMPS and the R TK PUMPS pushbutton switches are released (the OFF legends are on).
Subtask 49-31-00-865-053
B. Make sure that this(these) circuit breaker(s) is(are) closed:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FUEL/X FEED/VALVE/MOT1 2QE A12 49VU APU/FUEL/BLOW OFF/PUMP 2QC B14 121VU APU/FUEL/BLOW OFF/CTL 1QC K39 121VU APU/APU/CTL 2KD L42 121VU APU/ECB/SPLY 1KD L41 121VU APU/FUEL/LP VALVE/CTL 1QF M40 121VU APU/FUEL/LP VALVE/SPLY 2QF M39 121VU APU/FUEL/PUMP/CTL 3QC M38 121VU FUEL/X FEED/VALVE/MOT2 1QE M24 121VU FUEL/L WING TK/PUMP2 SPLY 7QA N26 121VU FUEL/L WING TK/PUMP1 SPLY 1QA N23 121VU FUEL/R WING TK/PUMP2 SPLY 8QA Q26 121VU FUEL/R WING TK/PUMP1 SPLY 2QA Q23
Subtask 49-31-00-010-057
C. Get Access
(1)
Open the LH main landing-gear (MLG) door (Ref. TASK 32-12-00-010-001).
(2)
Put the stepladder in position at the LH MLG door.
4. Procedure
_________ Subtask 49-31-00-710-053
A. Operational Test of the APU Fuel Low Pressure Circuit
NOTE : You can feel with your hand when the APU fuel pump operates.
____
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the ECAM control panel:
-push the APU pushbutton switch.
2. On the FUEL overhead panel 40VU:
-push the L TK PUMPS 1
pushbutton switch.
3. Start and operate the APU (Ref. TASK 49-00-00-860-003).
NOTE : Operate the APU with no
____ electric and/or pneumatic load.
4. On the FUEL overhead panel 40VU:
-release the L TK PUMPS 1
pushbutton switch.
5. On the circuit breaker panel 49VU: - open the circuit breaker
APU/FUEL/BLOW OFF/PUMP 2QC. On the circuit breaker panel 121VU: - open the circuit breaker
APU/FUEL/BLOW OFF/CTL 1QC.
On the lower ECAM display unit:
-
the APU page comes into view.
On the FUEL overhead panel 40VU:
-
the OFF legend in the L TK PUMPS 1pushbutton switch goes off.
At the APU fuel pump 4QC on theFR42/ZONE 140:
-
the APU fuel pump is off.
On the FUEL overhead panel 40VU:
-
the OFF legend in the L TK PUMPS 1pushbutton switch comes on.
At the APU fuel pump 4QC on the FR42/ZONE 140:
-
the APU fuel pump operates.
At the APU fuel pump 4QC on theFR42/ZONE 140:
-
the APU fuel pump stops.
On the lower ECAM display unit:
-the FUEL LO PR message comes on (after a short time).
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
6.
Do the APU shutdown (Ref. TASK 49-00-00-860-004).
7.
On the circuit breaker panel 49VU:
-
close the circuit breaker
APU/FUEL/BLOW OFF/PUMP 2QC. On the circuit breaker panel 121VU:
-
close the circuit breaker APU/FUEL/BLOW OFF/CTL 1QC.
8. On the APU section of the overhead panel 25VU:
-push the APU MASTER SW pushbutton switch to the on position.
9. On the APU section of the overhead panel 25VU:
-release the APU MASTER SW pushbutton switch to the off position.
NOTE : It is possible, that an APU AUTO
____ SHUTDOWN occurs.
On the lower ECAM display unit:
-the FUEL LO PR message goes off. NOTE : The ECB (59KD) stores the fault
____ message LOW FUEL PRESSURE CHECK APU FUEL SUPPLY (class 2).
On the APU section of the overheadpanel 25VU:
-
the ON legend in the APU MASTER SWcomes on.
At the APU fuel pump 4QC on the FR42/ZONE 140:
-
the APU fuel pump operates.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM 機載輔助動力 AIRBORNE AUXILIARY POWER4(14)
