F 『
 E C F M E
 E E
 E 56-5B E
 E E
 D. Referenced Information

 -------------------------------------------------------------------------------
REFERENCE  DESIGNATION
 -------------------------------------------------------------------------------
12-13-80-610-001 Drain and Replenish Oil System
 71-13-00-010-040 Opening of the Fan Cowl Doors
 71-13-00-410-040 Closing of the Fan Cowl Doors
 80-11-10-000-002 Removal of the Pneumatic Starter
 80-11-10-400-002 Installation of the Pneumatic Starter

R **ON A/C 001-049, 062-099, 101-101, 106-149, 151-199, 204-299, 301-399, R 401-499,
 80-11-10-991-300-A Fig. 601
 **ON A/C 051-061, 102-105, 201-203,
 80-11-10-991-300 Fig. 601A R **ON A/C 001-049, 062-099, 101-101, 106-149, 151-199, 204-299, 301-399,
R  401-499, 80-11-10-991-301-A Fig. 602 **ON A/C 051-061, 102-105, 201-203,
 80-11-10-991-301 Fig. 602A
 **ON A/C ALL
 3. Job Set-up
__________
 Subtask 80-11-10-941-052

 A. Safety Precautions
 (1) On the center pedestal, on the ENG panel 115VU:

 (a) Put a warning notice to tell persons not to start the engine.

 (2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.

 F 『 EEFF : ALL E Page 60280-11-10
 E E Aug 01/05 E E ECES E

 F 『
 E C F M E
 E E
 E 56-5B E
 E E
 (3) On the overhead maintenance panel 50VU:

 (a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.

 (b) Put a warning notice to tell persons not to energize the FADEC 1(2).

 Subtask 80-11-10-010-053
 B. Open the fan cowl doors: (Ref. TASK 71-13-00-010-040)
 FOR 1000EM1
 437AL, 438AR
 FOR 1000EM2
 447AL, 448AR

 4. Procedure
_________
R **ON A/C 001-049, 062-099, 101-101, 106-149, 151-199, 204-299, 301-399, R 401-499,
 (Ref. Fig. 601/TASK 80-11-10-991-300-A)
 **ON A/C 051-061, 102-105, 201-203,
 (Ref. Fig. 601A/TASK 80-11-10-991-300)
R **ON A/C 001-049, 062-099, 101-101, 106-149, 151-199, 204-299, 301-399, R 401-499,
 (Ref. Fig. 602/TASK 80-11-10-991-301-A)
 **ON A/C 051-061, 102-105, 201-203,
 (Ref. Fig. 602A/TASK 80-11-10-991-301)
 F 『 EEFF : ALL E Page 60380-11-10
 E E Aug 01/05 E E ECES E F 『 E C F M E E E

 E 56-5B E

 Engine Starter Inspection Figure 601/TASK 80-11-10-991-300-A
 F 『R EEFF : 001-049, 062-099, 101-101, 106-149, E Page 60480-11-10
 E E151-199, 204-299, 301-399, 401-499, Aug 01/05 E E ECES E F 『 E C F M E E E E 56-5B E

 Engine Starter Inspection
 Figure 601A/TASK 80-11-10-991-300

 F 『R EEFF : 051-061, 102-105, 201-203, E Page 60580-11-10
 E E May 01/05 E E ECES E F 『 E C F M E E E

 E 56-5B E

 Engine Starter Inspection Figure 602/TASK 80-11-10-991-301-A
 F 『R EEFF : 001-049, 062-099, 101-101, 106-149, E Page 60680-11-10
 E E151-199, 204-299, 301-399, 401-499, Aug 01/05 E E ECES E F 『 E C F M E E E E 56-5B E

 Engine Starter Inspection
 Figure 602A/TASK 80-11-10-991-301

 F 『R EEFF : 051-061, 102-105, 201-203, E Page 60780-11-10
 E E May 01/05 E E ECES ER **ON A/C 001-049, 062-099, 101-101, 106-149, 151-199, 204-299, 301-399, R 401-499,

 F  『
 E  C F M  E
 E  E
 E  56-5B  E
 E  E 

 Subtask 80-11-10-020-052-A

 A. Removal of Starter Magnetic Plug for Inspection.
 (1) Remove the knurled magnetic plug (90) from oil drain plug (110):
 (a) Push and turn counter-clockwise to release the plug (90). NOTE : The oil drain plug (110) has a built-in check valve to
____ permit removal of magnetic plug (90) without draining oil from the starter.
 **ON A/C 051-061, 102-105, 201-203,
 Subtask 80-11-10-020-052
 A. Removal of Starter Magnetic Plug for Inspection.
 (1) Remove magnetic plug (90): CAUTION : USE TWO STANDARD WRENCHES TO REMOVE/INSTALL THE MAGNETIC
_______ PLUG. ONE TO HOLD THE OIL DRAIN PLUG ADAPTER THE OTHER TO LOOSEN/TIGHTEN THE MAGNETIC PLUG. OTHERWISE ACCIDENTAL OIL DRAINING OF THE STARTER COULD OCCUR.
 (a) Cut and remove lockwire from the magnetic plug (90).

 (b) Remove magnetic plug (90) from oil drain plug (110) but be careful not to remove drain plug (110) while you remove the magnetic plug.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM 起動 STARTING(12)