-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
- open the circuit breaker - There is no change.
3QG(4QG).
13. On the overhead panel 20VU, on NOTE : Ignore other indications than____
the ENG/APU fire panel 1WD: the following ones.
A. Push, then release the ENG On the lower display unit the ECAM
1(2) FIRE pushbutton switch. system 4VU:
- the FUEL page is in view:
* the ACTUATOR LP FUEL SHUT OFF VALVE
ENG 1(2) is shown not in-line and in
amber.
B. Push the ENG 1(2) FIRE - the ACTUATOR LP FUEL SHUT OFF VALVE
pushbutton switch. ENG 1(2) is shown in-line and in
green.
14. On the overhead circuit breaker On the lower display unit of the ECAM
panel 49VU: system:
- Open the circuit breaker - There is no change (FUEL page).
1QG(2QG).
15. On the overhead panel 20VU, on
the ENG/APU fire panel 1WD:
A. Push, then release the ENG - the ACTUATOR LP FUEL SHUT OFF VALVE
1(2) FIRE pushbutton switch. ENG 1(2) is shown in-line and in
amber.
B. Push the ENG 1(2) FIRE - the ACTUATOR LP FUEL SHUT OFF VALVE
pushbutton switch. ENG 1(2) is shown in-line and in
green.
16. On the overhead circuit breaker On the lower display unit of the ECAM
panel 49VU and rear circuit system:
breaker panel 121VU:
- Close the circuit breakers - There is no change (FUEL page).
1QG(2QG) and 3QG(4QG).
17. On the F/O glareshield panel On the F/O glareshield panel 130VU and
130VU or CAPT glareshield panel CAPT glareshield panel 131VU:
131VU:
R 1EFF : 001-049, 051-099, 101-105, 151-199, 1 26-21-00Page 552 1201-228, 301-302, 1May 01/05 1 1 1CES 1
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
-push and release the MASTER - MASTER CAUT light goes off. CAUT pushbutton switch.
R **ON A/C 106-149, 229-299, 303-399, 401-499,
Subtask 26-21-00-710-063-A
A. Operational Test of the ENG 1(2) FIRE Pushbutton Switch
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. On the control panel of the ECAM NOTE : Make sure that you ignore other____
system (on the center pedestal indications that are not in the
panel 11VU): ones that follow.
On the lower display unit of the ECAM
system (on the center instrument panel
(4VU):
A. Push and release the BLEED - the BLEED page comes into view:
pushbutton switch. * the PACK-FLOW CONTROL VALVE 1(2) is
shown in-line and in green.
B. Push and release the HYD - the BLEED page goes out of view and
pushbutton switch. the HYD page comes into view:
* the VALVE-G(Y) PUMP FIRE ENG 1(2)
is shown in-line and in green.
C. Push and release the FUEL - the HYD page goes out of view and the
pushbutton switch. FUEL page comes into view:
* the ACTUATOR LP FUEL SHUT OFF VALVE
ENG 1(2) is shown in-line and in
green.
2. On the Multipurpose Control and On the MCDU 1(2) (on the center
Display Unit (MCDU) 1(2) (on the pedestal panel 11VU):
center pedestal panel 11VU): - make sure that the BIT 19 of the
- set the Bleed Monitoring LABEL 67(66) is at 0.
Computer (BMC) 1(2) CURRENT
STATUS page.
-------------------------------------------------------------------------------
ACTION RESULT -------------------------------------------------------------------------------
3. On the overhead circuit-breaker panel 49VU: On the MCDU 1(2) and on the lowerdisplay unit of the ECAM system:
- open the circuit breaker 1QG(2QG). - there is no change.
4. On the ENG/APU FIRE panel 1WD, (on the overhead panel 20VU):
- push, then release the ENG 1(2) FIRE pushbutton switch. - The single chime sounds.
On the ENG/APU FIRE panel 1WD, (on the overhead panel 20VU): - the SQUIB legend of the FIRE/AGENT 1 and 2 pushbutton switch comes on.
On the F/O glareshield panel 130VU and CAPT glareshield panel 131VU: - the two MASTER CAUT lights come on.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FIRE PROTECTION 防火2(21)
