Filter Assembly
Figure 401/TASK 21-26-43-991-006
R 1EFF : 001-049, 051-099, 101-105, 1 21-26-43Page 403 1 1 Config-1 May 01/05 1 1 1CES 1R **ON A/C 002-049, 051-099, 101-105,
Subtask 21-26-43-020-065-A
A. Remove the demister filter.
(1)
Remove the demister filter (Ref. TASK 21-26-43-600-010).
(2)
Remove the filter cartridge (Ref. TASK 21-26-43-600-011). NOTE : Close the door and lock the four elastic-fastener devices for
____
the removal of the body.
R **ON A/C 001-049, 051-099, 101-105,
Subtask 21-26-43-910-051
B. The body filter weighs approximately 4.6 kg (10.14 lb). Make sure that you support it correctly.
R **ON A/C 001-049, 053-099, 101-105,
Subtask 21-26-43-020-055
C. Remove the filter assembly.
(1)
Remove the clamps (1). NOTE : Do not discard the clamps (1). You must keep and use them
____
during the installation procedure.
(2)
Move the flexible sleeve (14) on the duct (15) to disengage the filter body (4).
(3)
Remove the clamp (9).
(4)
Release the drain hose (8).
(5)
Remove the 28 nuts (7) and screws (10) while you hold the equipped flange (12).
(6)
Remove the nuts (5) and the screws (2).
(7)
Remove the filter body (4).
R 1EFF : 001-049, 051-099, 101-105, 1 21-26-43Page 404 1 1 Config-1 May 01/05 1 1 1CES 1
(8) Remove the seal (11) and discard it.
(9) Put blanking plugs on the disconnected line ends.
R **ON A/C 051-052,
R Subtask 21-26-43-020-055-A
R C. Remove the filter assembly.
R (1) Remove the clamps (1).
R (2) Move the flexible sleeve (14) on the duct (15) to disengage the
R filter body (4).
R (3) Remove the clamp (9).
R (4) Release the drain hose (8).
R (5) Remove the 28 nuts (7) and screws (10) while you hold the equipped
R flange (12).
R (6) Remove the nuts (5) and the screws (2).
R (7) Remove the filter body (4).
R (8) Remove the seal (11) and discard it.
R (9) Put blanking plugs on the disconnected line ends.
R 1EFF : 001-049, 051-099, 101-105, 1 21-26-43Page 405 1 1 Config-1 May 01/05 1 1 1CES 1
R **ON A/C 001-049, 051-099, 101-105,
TASK 21-26-43-400-002
Installation of the Filter Assembly (2081HM,2082HM,2083HM)
1. Reason for the Job
__________________
Self Explanatory
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific access platform 1.6 m (5 ft. 3 in.)
B. Expendable Parts
-------------------------------------------------------------------------------
FIG.ITEM |DESIGNATION |IPC-CSN
-------------------------------------------------------------------------------
R 11 seal 21-26-01 03A-365 11 seal 21-26-01 03K-365
C. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
21-26-43-600-001 Servicing of the Demister Filter 21-26-43-600-002 Servicing of the Filter 21-26-43-600-010 Servicing of the Demister Filter (2081HM) 21-26-43-600-011 Servicing of the Filter Cartridge (2082HM) 24-41-00-861-002 Energize the Aircraft Electrical Circuits from the
External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied from the External Power 24-42-00-861-001 Energize the Ground Service Network from the External Power
R 1EFF : 001-049, 051-099, 101-105, 1 21-26-43Page 406 1 1 Config-1 May 01/05 1 1 1CES 1 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-42-00-862-001 De-energize the Ground Service Network Supplied from
the External Power 52-41-00-410-002 Close the Avionics Compartment Doors after Access 21-26-43-991-006 Fig. 401
3. Job Set-up
__________
Subtask 21-26-43-860-054
A. Aircraft Maintenance Configuration
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM AIR CONDITIONING 空調 2(70)
