曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

Then rinse engine clean with additional solvent and allow it to dry.
• Caution •
Do not operate the engine until excess solvent has evaporated
or otherwise been removed
5. Remove the protective tape from the magnetos.
6. Open induction system air inlet and install filter.
7. Lubricate the controls, bearing surfaces, etc., in accordance with
the Lubrication Chart.
Landing Gear
Before cleaning the landing gear, place a plastic cover or similar
material over the wheel and brake assembly.
1. Place a pan under the gear to catch waste.
2. Spray or brush the gear area with solvent or a mixture of solvent
and degreaser, as desired. Where heavy grease and dirt deposits
have collected, it may be necessary to brush areas that were
sprayed, in order to clean them.
3. Allow the solvent to remain on the gear from five to ten minutes.
Then rinse the gear with additional solvent and allow to dry.
4. Remove the cover from the wheel and remove the catch pan.
5. Lubricate the gear in accordance with the Lubrication Chart.
March 2010
8-30 Information Manual
Section 8 Cirrus Design
Handling, Servicing, Maintenance SR20
Cleaning Interior Surfaces
Seats, carpet, upholstery panels, and headliners should be vacuumed
at regular intervals to remove surface dirt and dust. While vacuuming,
use a fine bristle nylon brush to help loosen particles.
• Caution •
Remove any sharp objects from pockets or clothing to avoid
damaging interior panels or upholstery.
Windshield and Windows
Never rub dry acrylic. Dull or scratched window coverings may be
polished using a special acrylic polishing paste.
• Caution •
Clean acrylic windows with a solvent free, none abrasive,
antistatic acrylic cleaner. Do not use gasoline, alcohol,
benzene, carbon tetrachloride, thinner, acetone, or glass
window cleaning sprays.
Use only a nonabrasive cotton cloth or genuine chamois to
clean acrylic windows. Paper towel or newspaper are highly
abrasive and will cause hairline scratches.
• Note •
Wiping with a circular motion can cause glare rings. Use an up
and down wiping motion to prevent this.
To prevent scratching from dirt that has accumulated on the
cloth, fold cloth to expose a clean area after each pass.
1. Using a moist cloth or chamois, gently wipe the windows clean of
all contaminates.
2. Apply acrylic cleaner to one area at a time, then wipe away with a
soft, cotton cloth.
3. Dry the windows using a dry nonabrasive cotton cloth or chamois.
March 2010
Information Manual 8-31
Cirrus Design Section 8
SR20 Handling, Servicing, Maintenance
Cleaning Product Cleaning Application Supplier
Prist
Interior Windscreen and
Windows
Prist Aerospace
Optimax Display Screens PhotoDon
Mild Dishwasher Soap
(abrasive free)
Cabin Interior Any Source
Leather Care Kit
50689-001
Leather Upholstery Cirrus Design
Leather Cleaner
50684-001
Leather Upholstery Cirrus Design
Ink Remover
50685-001
Leather Upholstery Cirrus Design
Leather Conditioner
50686-001
Leather Upholstery Cirrus Design
Spot and Stain
Remover
50687-001
Leather Upholstery Cirrus Design
Vinyl Finish Cleaner
50688-001
Vinyl Panels Cirrus Design
Vinyl & Leather Cleaner
51479-001
Vinyl and Leather
Upholstery
Cirrus Design
Figure 8-3
Recommended Interior Cleaning Products
March 2010
8-32 Information Manual
Section 8 Cirrus Design
Handling, Servicing, Maintenance SR20
Instrument Panel and Electronic Display Screens
The instrument panel, control knobs, and plastic trim need only to be
wiped clean with a soft damp cloth. The multifunction display, primary
flight display, and other electronic display screens should be cleaned
with Optimax - LCD Screen Cleaning Solution as follows:
• Caution •
To avoid solution dripping onto display and possibly migrating
into component, apply the cleaning solution to cloth first, not
directly to the display screen.
Use only a lens cloth or nonabrasive cotton cloth to clean
display screens. Paper towels, tissue, or camera lens paper
may scratch the display screen.
Clean display screen with power OFF.
1. Gently wipe the display with a clean, dry, cotton cloth.
2. Moisten clean, cotton cloth with cleaning solution.
3. Wipe the soft cotton cloth across the display in one direction,
moving from the top of the display to the bottom. Do not rub
harshly.
4. Gently wipe the display with a clean, dry, cotton cloth.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：西銳20飛機信息手冊CIRRUS DESIGN SR20 AIRPLANE INFORMATION MA(98)