曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

lever, HP RPM should steadily increase toward idle. Monitor TGT.
NOTE: The engine should normally light up within ten (10) seconds and
reach idling RPM in approximately forty-five (45) seconds. When the
engine runs satisfactorily, select Airstart Ignition OFF (IGN Message
OUT). Advance power lever slowly to desired RPM.
If the engine fails to relight after airstart ignition has been
energized for thirty (30) seconds, or if it appears unlikely that the
engine will accelerate to idle, proceed as follows:
1. HP Fuel Cock .........................................................................SHUT
2. Airstart Ignition ....................................OFF (IGN MESSAGE OUT)
3. Power Lever .............................................................................IDLE
Before attempting another relight, allow engine to drain for at least
thirty (30) seconds. Try again at lower altitude.
END
One (1) Engine Inoperative Landing Procedure
AFM 4-10-40
1. Normal Before Landing Checklist (Page NE-2) ...........COMPLETE
2. Airspeed...................................VREF (FOR 20° FLAPS) +10 KCAS
At Final Approach Fix:
3. Flaps .......................................................................................... 39°
NOTE: Selecting 39° flaps at this point in the approach assumes
that the landing weight is at or below max landing weight. If IMC
(Instrument Meteorological Conditions), continue the approach at 20°
flaps at VREF 20° +10 kts. See Performance, Landing Planning
Data, for landing distance in the flaps 20° configuration.
Continued on next page →
Quick Reference Handbook
REVISION 8 ABNORMAL / EMERGENCY PROCEDURES
Oct 11/02 Page EC - 11
One (1) Engine Inoperative Landing Procedure, ctd… AFM 4-10-40
4. Airspeed ............................................................... VREF 39° FLAPS
After Landing:
5. Operating Engine Thrust Reverser..........................AS REQUIRED
END
One (1) Engine Inoperative Go-Around Procedure
AFM 4-10-50
1. Power Lever .....................................................................................
........................GO-AROUND POWER ON OPERATING ENGINE
2. Flaps........................................................................................... 20°
3. Airspeed ................................ VREF (FOR 20° FLAPS) +5 KNOTS
4. Landing Gear....................................................................................
......RETRACT WHEN POSITIVE RATE OF CLIMB IS ATTAINED
5. Flaps............................ UP WHEN VREF (20° FLAPS) +20 KNOTS
(MAINTAIN SPEED FOR ADEQUATE STALL MARGIN)
6. Power .....................................MAXIMUM CONTINUOUS POWER
NOTE: Final segment climb performance is based on setting
maximum continuous power on operating engine.
END
Reverse Thrust Unlock or Deploy AFM 4-24-10
1. During takeoff, if the REV UNLOCK and / or REV DEPLOY light
and REV UNLOCK warning activate, proceed as follows:
A. At speeds below V1; ABORT takeoff and perform Engine
Failure During Takeoff Below V1 Speed, page EC-2.
B. At speeds above V1; reduce power of affected engine and
continue as with one engine inoperative.
C. Maintain airspeed less than 200 KCAS.
Continued on next page →
Quick Reference Handbook
ABNORMAL / EMERGENCY PROCEDURES REVISION 8
Page EC - 12 Oct 11/02
Reverse Thrust Unlock or Deploy, ctd… AFM 4-24-10
D. When the situation permits, depress the T / REV EMER
STOW switch. If warning message and lights extinguish, land
as soon as practical. Reverse thrust will not be available on
landing. Both engines will be available for landing.
E. If thrust reverser does not restow (warning message and lights
illuminated), land as soon as possible using maximum of 20°
flaps if T/R doors are actually deployed.
F. If actuating the T / REV EMER STOW switch causes the
opposite REV UNLOCK light to illuminate, deselect T / REV
EMER STOW switch and land as soon as practical.
2. During flight, if the REV UNLOCK and / or REV DEPLOY lights
and appropriate EICAS warning illuminates; proceed as follows:
NOTE: The REV UNLOCK light may illuminate at high power settings if
hydraulic system pressure is lost.
A. Ensure the reverser power levers are in the stowed position
and retard power lever of the affected engine to idle.
B. Reduce airspeed to less than 200 KCAS.
C. Depress the T / REV EMERG STOW switch. If the Warning
message and lights extinguish, leave switch depressed for
remainder of flight and land as soon as practical. Both engines
are available for remainder of flight.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：灣流4快速檢查單QRH GULFSTREAM IV QUICK REFERENCE HANDBOOK 3(30)