DESCRIPTION
General 19−10−1
Flat-Rated Thrust 19−10−1
Engine Construction 19−10−1
Description 19−10−1
Engine Fuel System 19−10−3
Description 19−10−3
Components and Operation 19−10−3
Automatic Performance Reserve System 19−10−5
Description 19−10−5
Operation 19−10−6
Engine Oil System 19−10−6
Description 19−10−6
Components and Operation 19−10−6
Engine Bleed Air System 19−10−11
Description 19−10−11
Components and Operation 19−10−11
Engine Starting System 19−10−12
Description 19−10−12
Components and Operation 19−10−13
Ignition System 19−10−15
Description 19−10−15
Operation 19−10−15
Vibration Monitoring System 19−10−16
Description 19−10−16
Operation 19−10−17
Thrust Levers 19−10−17
Description 19−10−17
Operation 19−10−17
Thrust Reverser System 19−10−19
Description 19−10−19
Operation 19−10−19
Controls and Indicators 19−10−23
Engine Starting 19−10−23
Engine Speed Controls 19−10−24
POWER PLANT
Table of Contents
Vol. 2 19−00−1
Oct 05/06
CHAPTER 19 - POWER PLANT
19−00−1
CL−605 Flight Crew Operating Manual
PSP 605−6
TABLE OF CONTENTS
Page
TABLE OF CONTENTS
DESCRIPTION
Thrust Levers 19−10−25
Reverse Thrust 19−10−26
Oil System 19−10−26
EICAS Page 19−10−27
EICAS Messages 19−10−31
SUMMARY
Power Supply and Circuit Breaker Summary 19−20−1
LIST OF ILLUSTRATIONS
DESCRIPTION
Figure 19−10−1 Flow Distribution 19−10−2
Figure 19−10−2 Engine Fuel System − Schematic 19−10−4
Figure 19−10−3 ENGINE CONTROL Panel 19−10−5
Figure 19−10−4 ENGINE CONTROL Panel 19−10−6
Figure 19−10−5 Oil System Schematic 19−10−8
Figure 19−10−6 Oil Replenishment System 19−10−10
Figure 19−10−7 Engine Bleed Air System − Schematic 19−10−12
Figure 19−10−8 Starting System − Schematic 19−10−13
Figure 19−10−9 Engine Start/Ignition Panel 19−10−14
Figure 19−10−10 Ignition System 19−10−16
Figure 19−10−11 ENGINE CONTROL Panel 19−10−17
Figure 19−10−12 Thrust Levers 19−10−19
Figure 19−10−13 Thrust Reverser Operation 19−10−21
Figure 19−10−14 GND SPOILERS/THRUST REVERSER Panel 19−10−22
Figure 19−10−15 Engine Start/Ignition Panel 19−10−23
Figure 19−10−16 ENGINE CONTROL Panel 19−10−24
Figure 19−10−17 Thrust Levers 19−10−25
Figure 19−10−18 GND SPOILERS/THRUST REVERSER Panel 19−10−26
Figure 19−10−19 Impending Bypass and Chip Detector Annunciators (JB5) 19−10−26
Figure 19−10−20 N1 Indications 19−10−27
Figure 19−10−21 ITT Indications 19−10−28
Figure 19−10−22 N2 Indications 19−10−29
Figure 19−10−23 Engine Secondary Indications 19−10−30
POWER PLANT
Table of Contents
Vol. 2 19−00−2
Oct 05/06
CL−605 Flight Crew Operating Manual
PSP 605−6
Page
GENERAL
The Challenger 605 is equipped with two General Electric CF34-3B high-bypass ratio turbofan
engines.
The dual-assembly engine consists of a fan rotor (N1) and a compressor rotor (N2). The N1 rotor is
comprised of a single-stage fan connected through a shaft to a four-stage low-pressure turbine. The
N2 rotor is a 14-stage axial flow compressor connected through a shaft to a two-stage high-pressure
turbine. The accessory gearbox is mechanically driven by the N2 compressor.
Normal takeoff thrust rating is 8,729 pounds per engine. During engine-out operation, the automatic
performance reserve (APR) system increases thrust on the operable engine to 9,220 pounds.
FLAT-RATED THRUST
Outside air temperature and pressure altitude are determining factors in achieving takeoff and APR
power. Increases in ambient temperature or pressure altitude adversely affect the engine’s ability to
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：龐巴迪挑戰者605機組操作手冊 CL605-POWER_PLANT