曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

UUT RF CARRIER LEVEL
RD-AA5002-12 without MOD2 108 dBmV (±3 dB)
RD-AA5002-12 with MOD2 102 dBmV (+3/-4 dB)
RD-AA5002-22 without MOD4 108 dBmV (±3 dB)
RD-AA5002-22 with MOD4 102 dBmV (+3/-4 dB)
RD-AA5002-23 without MOD3 108 dBmV (±3 dB)
RD-AA5002-23 with MOD3 102 dBmV (+3/-4 dB)
RD-AA5002-25 102 dBmV (+3/-4 dB)
(5) VMU Tuner Setting
(a) Make sure that the VMU tuner shows as follows:
DISPLAY DATA
CH 01
FREQ 151.25 or different frequency value
NOTE: If the VMU tuner shows "E0" or "E2" on the CH display, the
VMU tuner must be repaired before you can use it.
(b) Do a scan of channels 1 thru 12 with the UP or DOWN switch
pushed and make sure that the default receiving frequencies are
set on these channels (refer to Figure 102). If not, set the
default receiving frequencies as follows:
1 Set the ADJUST-NORMAL switch to ADJUST.
2 Push the RESET switch for three seconds.
3 Set the ADJUST-NORMAL switch to NORMAL.
4 Do a scan of channels 1 thru 12 again to make sure that the
default receiving frequencies are set.
(6) Go to Functional Testing (5.).
Page 123
Feb 20/2002
Matsushita Avionics Systems Corporation
COMPONENT MAINTENANCE MANUAL
PART NUMBER RD-AA5002 SERIES
23-32-47
5. Functional Testing
Do the tests in the sequence given. You can do all tests other than the RF
level tests during the two-hour warm-up time.
A. Start of Program
(1) Make sure that the PC's COM1 connector is connected to the tester's
RS232C I/F connector.
(2) Put the VMU test disk into the PC's floppy disk drive.
(3) Set the PC's power switch to ON. In less than two minutes, you will
see the screen as shown in Figure 103B.
RD-AA5002 VIDEO MODULATOR UNIT TEST PROGRAM
SOFTWARE P/N MD2HD256005D
VERSION 1.02
ENTER COMPLETE MODEL AND DASH NUMBER ?
NOTE: This is an example only. The software part number and version
number that are shown on the screen can be different.
PROGRAM'S FIRST SCREEN
Figure 103B
(4) Type the part number of the VMU (use only capital letters, dash "-"
and numbers), then push the Enter key. The basic part number must
be "RD-AA5002". The program does not make a check of the dash
number, but accepts all dash numbers. You will see the screen as
shown in Figure 103C.
RD-AA5002 VIDEO MODULATOR UNIT TEST PROGRAM
SOFTWARE P/N MD2HD256005D
VERSION 1.02
ENTER COMPLETE MODEL AND DASH NUMBER ? RD-AA5002-12
ENTER UNIT SERIAL NUMBER ?
PROGRAM'S SECOND SCREEN
Figure 103C
Page 124
Feb 20/2002
Matsushita Avionics Systems Corporation
COMPONENT MAINTENANCE MANUAL
PART NUMBER RD-AA5002 SERIES
23-32-47
(5) Type the UUT's 6-digit serial number or the number part of the UUT's
"letter + 6-digit number" serial number (2001 production and after),
then push the Enter key. You will see the screen as shown in Figure
103D.
RD-AA5002 VIDEO MODULATOR UNIT TEST PROGRAM
SOFTWARE P/N MD2HD256005D
VERSION 1.02
ENTER COMPLETE MODEL AND DASH NUMBER ? RD-AA5002-12
ENTER UNIT SERIAL NUMBER ? 123456
CHECK POWER AND REMOTE CONTROL CONNECTIONS TO VMU
ENSURE THAT RTS-CTS, DSR, DCD, AND DTR LINES ON COMPUTER
ARE PROPERLY CONNECTED (PINS 4 to 5, 6 & 8 to 20 on 25 pin)
or PINS 7 to 8, 6 & 1 to 4 on 9 pin COM 1 RS-232 connector).
PRESS ANY KEY TO CONTINUE
PROGRAM'S THIRD SCREEN
Figure 103D
(6) Push the Enter key or other key to continue. You will see the main
screen as shown in Figure 103E.
Go to:
· Step (7) if you see the main screen as shown in Figure 103E.
· Step (8) if the main screen does not show the frequency and time
values for all channels.
· Step (9) if the main screen shows the frequency and time values
only for some of the channels.
Page 125
Feb 20/2002
Matsushita Avionics Systems Corporation
COMPONENT MAINTENANCE MANUAL
PART NUMBER RD-AA5002 SERIES
23-32-47
02-04-2002 RD-AA5002-12 VIDEO MODULATOR UNIT, SERIAL NUMBER 123456 17:31:29
FREQUENCY FOR CHANNEL 01 151.25 17:24:01 NORMAL VIDEO
FREQUENCY FOR CHANNEL 02 163.25 17:24:01 BITE OFF
FREQUENCY FOR CHANNEL 03 175.25 17:24:01
FREQUENCY FOR CHANNEL 04 187.25 17:24:01
FREQUENCY FOR CHANNEL 05 199.25 17:24:02
FREQUENCY FOR CHANNEL 06 211.25 17:24:02
FREQUENCY FOR CHANNEL 07 223.25 17:24:02
FREQUENCY FOR CHANNEL 08 235.25 17:24:02
FREQUENCY FOR CHANNEL 09 247.25 17:24:02
FREQUENCY FOR CHANNEL 10 259.25 17:24:02
FREQUENCY FOR CHANNEL 11 271.25 17:24:02
FREQUENCY FOR CHANNEL 12 283.25 17:24:02
COMMAND @12? RESPONSE &BOFF
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：COMPONENT MAINTENANCE MANUAL Video Modulator Unit (VMU)(33)