曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

JP4 is like Jet B but also has a
corrosion inhibitor and anti-icing
additives. It was the main military
fuel but is being superseded by JP8,
at least in the USA. JP5 has a higher
flashpoint than JP4, and was
designed for US navy ships (similar
to Jet A). JP8 is like Jet A1, but has a
full set of additives.
FCU
The Fuel Control Unit does more or
less the same job as a carburettor on
a piston engine, but it uses springs
and bobweights to metre fuel
according to demand.
Engines & Systems 55
FADEC
The initials stand for Full Authority
Digital Electronic Control. It's just a
computer that controls the fuel
system, based on information from
various sensors, such as exhaust
temperature, engine RPM, control
movement, etc. The end result is a
more precise control of rotor speeds
under varying flight conditions,
particularly with reference to
overspeeding. Other benefits include
automatic starting, better care of the
engine (so more time between
overhauls) and reduction of pilot
workload through automation. Being
a computer, it is software-based, and
one of the preflight checks is to
ensure that the right software is
loaded. Also, because it's a
computer, it's able to monitor many
parameters, which is why you might
see more caution lights.
It will typically consist of two main
items, the Engine Control Unit (ECU),
on the airframe, with a processor
inside (e.g. a 486 – powerful, huh?),
and the Hydro Mechanical Unit (HMU)
on the engine, which functions
rather like the old-style FCU when
the FADEC is disabled. There will
also be sensors and relays for the
transmission of information around
the system. Many signals will be
repeated to the relevant instruments.
Engine Instruments
Refer to the Instruments chapter.
Engine Handling
One of the biggest things to unlearn
when transitioning from piston to
turbine is to keep your finger on the
starter button once things start
happening (with a piston, you tend
to take your finger off straight away
when the engine starts). You take
your finger off when the engine
becomes self-sustaining. Before then, it
relies heavily on the battery or APU
to keep it turning. It follows that, if
the battery is weak to start with, the
engine won't spin as fast, the airflow
is reduced, the whole process
becomes hotter and you could melt
the back end with a hot start. You
should always check the voltage
available from the battery before
starting a turbine engine. A hung start
exists when the engine fails to
accelerate to normal idle RPM. It
just sits there, weakening the battery
and leading to a hot start. You get a
wet start when the engine doesn't
light off at all (flooded).
Pulling full power just because it's
there is not always a good idea.
Limitations may be there for other
reasons—for example, the
transmission might not be able to
take that much, which is why you
can’t go faster than 80 kts in a
Jetranger when pulling more than
85% torque (actually, in this case, the
transmission ends up in a strange
attitude). Excessive use of power will
therefore ruin your gearbox well
before the engine (and will show up
as metal particles in the oil).
Maximum Continuous Power is the
setting that may be used indefinitely,
but any between that and maximum
power (usually shown as a yellow arc
on the instrument) will only be
available for a set time limit.
While I'm not suggesting for a
moment that you should, piston
engines will accept their limits being
slightly exceeded from time to time
with no great harm being done.
Having said that, the speed at which
the average Lycoming engine
56 JAR Private Pilot Studies
disintegrates is about 3450 RPM,
which doesn't leave you an awful lot
of room when it runs normally (in a
Bell 47, anyway) at 3300! Turbines,
however, are less forgiving than
pistons and give fewer warnings of
trouble because of the closer
tolerances to which they are made.
This is why regular power checks
(once a week) are carried out on
them to keep an eye on their health.
The other difference is that damage
to a piston engine caused by
mishandling tends to affect you,
straight away, whereas that in a
turbine tends to affect others down
the line. In a turbine-engined
helicopter, power used is indicated
by the torquemeter.
Apart from sympathetic handling,
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：JAR.Private.Pilot.Studies(39)