Table 1 - Parts List
Additional items required: In addition to the kit, the following are examples of parts and tools that may be required, but are not provided:
. Miscellaneous tools: Drill, Phillips screwdriver (#2 bit), center punch, wire stripper, wrenches for aircraft disassembly/assembly
. Soldering iron & solder
. Metal & fabricating tools/equipment to fabricate ELT and buzzer mounts
. 1/2 A slow-blow fuse and holder (or comparable circuit breaker) for cockpit remote indicator
. Shielded cable – 22 AWG (typical), 4-conductor
NOTE: The use of 22 or 24 AWG is suggested but larger diameter wire may be used. All Artex testing and qualification was done using 22 and 24 AWG wire. Use a high quality wire such as MIL-W-16878 or M22759 or their commercial equivalent.
. Harness securing fasteners / materials
. Miscellaneous hookup wire – 22 AWG (typical)
. Molex connector pin crimp tool P/N HTR1719C (generic P/N 11-01-0008) or equivalent
. Terminal extraction tool – Molex P/N 11-03-0002 or equivalent
. Electronics grade RTV for sealing connector pins
. Tools to install antenna, ELT
2.3 Mount ELT
Three separate mounting-hole patterns are provided so that, if the ME406P is replacing an existing ELT indicated on the list below, the original mounting holes can be used. Remove the old ELT holder or tray and install the ME406P mounting tray in its place. Use the 8-32 X 5/8” Phillips, pan-head screws, nuts and flat washers provided. You may provide your own hardware so long as the correct size and type is used. Mounting screws are English 8-32 or M5 x length as required. Stainless steel hardware is recommended. Use hardware conforming to an accepted standard such as AN or Mil-Spec.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：DESCRIPTION, OPERATION, INSTALLATION AND MAINTENANCE MANUAL ME406P ELT(12)
