曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 Observe that ENG START selector returns to AUTO position.
 Observe that duct pressure returns to its original level. This verifies start valve closure.
 After start valve has been closed, restore bleed air system to required configuration.
2. If duct pressure does not return to original level (also indicated by an EICAS STARTER CUTOUT message):
 Accomplish STARTER CUTOUT procedure (see QRH Non-Normal Checklist). Assume VALVE light remains illuminated.
CAUTION: MANUAL OPERATION OF THE START VALVE WITHOUT AIR PRESSURE IN START DUCT
MAY DAMAGE VALVE.
 Shut down associated engine. Dispatch is not allowed. See MMEL item 80-00-2 Engine Start Valves.
 
REPAIR INTERVAL C 2 NUMBER INSTALLED
ITEM   1 NUMBER REQUIRED FOR DISPATCH
    REMARKS OR EXCEPTIONS
(M) (O) One may be inoperative provided:
 The associated start VALVE light operates normally,
 Manual override start procedures are used.
80-00-2 Engine Start Valves    

EICAS STATUS MESSAGES
None
PLACARD
Associated start selector (overhead panel) - START VALVE INOP MAINTENANCE (M)
CAUTION: MANUAL OPERATION OF THE START VALVE WITHOUT AIR PRESSURE IN START DUCT
MAY DAMAGE VALVE.
CAUTION: CLOSE VALVE PROMPTLY UPON COMMAND TO AVOID STARTER DAMAGE.
 Establish communication with flight deck.
CAUTION: DO NOT USE SHORTER EXTENSIONS TO MAKE UP THE 18-INCH EXTENSION.
DAMAGE TO ENGINE COULD RESULT.
 Insert a 3/8-inch square drive 18-inch extension through access port in right fan cowl and engage drive into valve override internal receptacle.
 Upon command from flight deck, rotate the drive to open the valve.
 Upon command from flight deck, promptly rotate the drive to close the valve.
 Remove the drive from the access port.
 
 
ACCESS PORT
START VALVE ACCESS
OPERATIONS (O)
MANUAL OVERRIDE START
Perform normal engine start procedure except:
 Announce “OPEN START VALVE.” Position the engine start selector to GND.
 At 51% N2 announce “CLOSE START VALVE.” Verify that the engine start selector returns to AUTO, and that the start VALVE light on the overhead panel momentarily illuminates, then extinguishes.
AIR START
If an inflight restart becomes necessary, ensure that airspeed is sufficient for a windmilling start (see Airplane Flight Manual speed requirements).
 
EICAS STATUS MESSAGES
None
PLACARD
As appropriate
OPERATIONS (O)
 Manually hold the start selector in the GND position for engine start.
 Rotate the start selector to the AUTO position at 51-52% N2.
CAUTION: DELAYING ROTATION OF THE START SELECTOR TO THE AUTO POSITION CAN CAUSE
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 最低設備清單 Minimum Equipment List (MEL) 2(89)