曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

2. DESCRIPTION
5 mooring points are provided on the aircraft :
- 1 mooring hole on each one of the 4 wing flap hinge arms,
- 1 mooring fitting located under the horizontal stabilizer.
WA
Validity : S / N 1 - 9999 10-20-00 Page 1
(BA) JUN 01
 
PAGE INTENTIONALLY LEFT BLANK
WA
Validity : S / N 1 - 9999 10-20 Page 2
00 (BA) JUN 01
 
MOORING
MAINTENANCE PRACTICES
1. SERVICING - MOORING
A. Tools and consumable materials
- Wheel chocks
- Ropes
B. Mooring procedure
A correct mooring procedure is the best protection against damage to parked aircraft by gusty or strong winds. To moor the aircraft securely, proceed as follows :
1) Install the control surfaces locking device - refer to 10-10-00.
2) Place chocks against all wheels.
3) Use sufficiently strong ropes or chains to tie down the aircraft ; insert a rope in each mooring hole located on the wing flap hinge arms and in the hole of the rear mooring fitting located under the horizontal stabilizer ; tie each rope to a mooring point or post.
4) Make sure the doors are closed and locked.
WA
Validity : S / N 1 - 9999 10_20_00 Page 201
(BA) JUN 01
 
PAGE INTENTIONALLY LEFT BLANK
 
RETURN TO SERVICE
DESCRIPTION AND OPERATION
1. GENERAL
This section briefly deals with the operations to be carried out to return the aircraft to service after a storage period.
 
PAGE INTENTIONALLY LEFT BLANK
WA
Validity : S / N 1 - 9999
10-30-00Page 2
(BA) JUN 01
 
RETURN TO SERVICE
MAINTENANCE PRACTICES
1. SERVICING - RETURN TO SERVICE
A. Tools and consumable materials - Wheel chocks
B. Destorage procedure
CAUTION : BEFORE RETURNING THE AIRCRAFT TO SERVICE AFTER A LONG-TIME STORAGE (MORE THAN 6 MONTHS), THE AIRCRAFT MUST BE DESTORED AND AN OVERALL INSPECTION CARRIED OUT IN ACCORDANCE WITH THE PERIODIC INSPECTIONS PROTOCOL, 100-HOUR INSPECTION - REFER TO 05-20-04, OR THE MAJOR INSPECTION PROTOCOL - REFER TO 05-20-05, DEPENDING ON STORAGE DURATION AND CONDITIONS.
1) Untie the mooring ropes - refer to 10-20-00.
2) If the aircraft is stored in a hangar, lower the aircraft to ground and remove the jacks - refer to 07-10-00. Install the wheel chocks.
3) Remove all protective covers and blanking plugs.
4) Clean the aircraft if necessary - refer to 12-20-03.
5) Lubricate the aircraft - refer to 12-21-00.
6) Bleed the fuel tanks and the fuel system - refer to 12-11-02.
7) Check the fluid level of the brake reservoir - refer to 12-13-01.
8) Apply the parking brake. Check for hydraulic fluid leaks or oozing.
9) Remove the control surfaces locking device - refer to 10-10-00.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：TB20 MAINTENANCE MANUAL 10 TB20飛機維護手冊 10 停放,系留,貯存和恢復使用(5)