4.  
Establishes and maintains a stabilized approach at the recommended airspeed, with gust correction factor applied, ±5 knots.

5.  
Maintains proper ground track with crosswind correction, if necessary.

6.  
Remains aware of the possibility of wind shear and/or wake turbulence.

7.  
Makes smooth, timely, and correct control application during the flare and touchdown.

8.  
Touches down smoothly, with little or no float beyond and within 100 feet (30 meters) of a specified point with no appreciable drift, and with the longitudinal axis aligned with the intended landing path.

9.  
Applies brakes, as necessary, to stop in the shortest distance consistent with safety.

10. Completes the prescribed checklist, if applicable.
G. TASK: GO-AROUND
REFERENCES: AC 61-21; Gyroplane Flight Manual.
Objective. To determine that the applicant:
1.  
Exhibits knowledge of the elements related to a go-around and when it is necessary.

2.  
Makes a timely decision to discontinue the approach to landing.

3.  
Applies appropriate power and establishes a climb at the appropriate airspeed, ±5 knots.

4.  Maintains takeoff power to a safe maneuvering altitude, then sets climb power.
5.  
Maintains proper ground track with crosswind correction, if necessary.

6.  
Completes the prescribed checklist, if applicable.

V.  AREA OF OPERATION: PERFORMANCE MANEUVER
TASK: STEEP TURNS
REFERENCES: AC 61-21; Gyroplane Flight Manual.
Objective. To determine that the applicant:
1.  
Exhibits knowledge of the elements related to steep turns.

2.  
Selects a safe altitude.

3.  
Establishes and maintains the appropriate entry speed (or in its absence, the design maneuvering speed), ±10 knots.

4.  
Smoothly enters a coordinated steep 360° turn with a 40° bank, ±5°, immediately followed by at least a 360° turn in the opposite direction.

5.  
Divides attention between gyroplane control and orientation.

6.  
Rolls out on the entry heading, ±10°.

7.  
Maintains the entry altitude throughout the maneuver, ±100 feet (30 meters).

VI. AREA OF OPERATION: GROUND REFERENCE MANEUVERS
A. TASK: RECTANGULAR COURSE
REFERENCE: AC 61-21.
Objective. To determine that the applicant:
1.  
Exhibits knowledge of the elements related to a rectangular course.

2.  
Selects an appropriate ground reference based on wind direction and emergency landing areas.

3.  
Plans the maneuver to enter at traffic pattern altitude, at an appropriate distance from the selected reference area, 45° to the downwind leg.

4.  
Maintains a constant ground track around the rectangular reference area.

5.  
Divides attention between gyroplane control and orientation.

6.  
Maintains the entry altitude throughout the maneuver, –100 feet (30 meters) and airspeed, –10 knots.

B. TASK: S-TURNS
REFERENCE: AC 61-21.
Objective. To determine that the applicant:
1.  
Exhibits knowledge of the elements related to S-turns.

2.  
Selects an appropriate reference line based on wind direction and emergency landing areas.

3.  
Plans the maneuver to enter at traffic pattern altitude, perpendicular to the selected reference line, downwind.

4.  
Compensates for the wind so that each half-circle is equal on either side of the selected reference line.

5.  
At each reversal of direction, cross the reference line at a 90° angle in a level attitude.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：PRIVATE PILOT Practical Test Standards for ROTORCRAFT HELICO(27)