曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

This location information goes to the ADIRU and SAARU on a flight controls ARINC 629 bus.
Pitot Probe and AOA Sensor Heat Control
The left pitot ADM controls the heat for the left pitot probe. The center pitot ADM controls the heat for the center pitot probe. The right pitot ADM controls the heat for the right pitot probe.
The left pitot ADM controls the heat for the left AOA sensor. The right pitot ADM controls the heat for the right AOA sensor.
The pitot ADMs control the heat control relays in the power management panels. The heat control comes from data the ADMs receive from the primary flight computers (PFCs) through the flight controls ARINC 629 bus. If the PFCs are not valid, the ADMs use data from the autopilot flight director computers (AFDCs). The AFDC data also comes through the flight controls
ARINC 629 bus. 
The ADMs supply a management panels conditions are true:  ground when the  heat PF signal Cs report  to  the these  power two 
* The airplane is on th e ground 
EFFECTIVITY BEJ ALL 

* An engine running.
The ADMs supply an air heat signal to the power management panels when any of these conditions is true:
*
The airplane is in the air

*
Computed airspeed (CAS) is more than 50 kts.

The power management panels connect the ground heat and the air heat signals to current sense relays to control the voltage to the pitot probes. The ADMs monitor the pitot probe and AOA heaters through three electrical input discretes. The ADM transmits heater fault data on the flight controls bus.
For information on how to do a test of the pitot probe and the AOA sensor heat operation, see Ice and Rain Protection. (CHAPTER 30)
ADM Software Loading
The ADM can receive operational program software (OPS) from the AIMS cabinets through the flight controls ARINC 629 bus. You load the same software for pitot and static ADMs.
The ADM keeps the OPS in non-volatile memory (NVM).
34-20-00

Page 57 D633W101-BEJ Sep 05/2002

ADIRS -AIR DATA MODULE
Fault Data
The ADM sends fault and operational status data to the central maintenance computing function (CMCF) of the AIMS. The CMCF can command the ADM to test the pitot heaters and AOA heaters.
EFFECTIVITY BEJ ALL  34-20-00 
Page 58 
D633W101-BEJ  Sep 05/2002 

 

777 AIRCRAFT MAINTENANCE MANUAL

ADIRS -AIR DATA MODULE

EFFECTIVITY BEJ ALL  34-20-00 
Page 59 
D633W101-BEJ  Jan 05/2002 

ADIRS -SECONDARY ATTITUDE AIR DATA REFERENCE UNIT

General Standby Instruments
The secondary attitude air data reference unit (SAARU) is a The SAARU supplies attitude data to the standby attitude backup source of attitude and air data. indicator through the ARINC 429 bus.
Physical Description
The SAARU weighs 30 pounds. It uses passive cooling. Cooling fins take heat away from the SAARU.
Software Load
The SAARU can receive new software from the flight controls ARINC 629 data bus. The software data modifies the operational program of the SAARU.
Sensors and Circuits
The SAARU has these components:
*
Four fiber optic gyros

*
Four linear accelerometers

*
Two central processing units (CPUs)

*
Three ARINC 629 interface modules.

*
Two power supplies.

Three fiber optic gyros and three accelerometers are aligned with the roll, pitch, and yaw axis. The fourth fiber optic gyro and fourth accelerometer allow the SAARU to detect any faults in the other three.
EFFECTIVITY BEJ ALL  34-20-00 
Page 60 
D633W101-BEJ  Sep 05/2002 

 

ADIRS -SECONDARY ATTITUDE AIR DATA REFERENCE UNIT

EFFECTIVITY BEJ ALL  34-20-00 
Page 61 
D633W101-BEJ  Jan 05/2002 

ADIRS -SAARU INERTIAL REFERENCE DATA FUNCTION

General
The secondary attitude air data reference unit (SAARU) uses gyros and accelerometers to calculate inertial reference data. The inertial reference data goes to airplane systems.
Power
The SAARU gets power from a circuit breaker in the center power supply assembly. The circuit breaker gets power from the center flight control DC bus.
Gyros and Accelerometers
The gyros and accelerometers measure rotation rates and accelerations. The rotation rates and accelerations go to buffers. The buffers supply the rotation rates and accelerations to the central processing unit which calculate SAARU data.
SAARU Data
The SAARU calculates this inertial reference data:
*
Body frame accelerations

*
Body frame angular rates

*
Attitude (roll and pitch)

*
Horizontal and vertical accelerations
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：777 AMM 飛機維護手冊 導航 Navigation 1(13)