33-41-00
 ALL  ú ú 01 Page 1 ú Oct 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 WING ILLUMINATION LIGHTS - MAINTENANCE PRACTICES
________________________________________________
 1.  General_______
 A. This procedure contains these tasks:
 (1)  
A task for the replacement of the lamps in the wing illumination lights.

 (2)  
A task for the adjustment of the wing illumination lights.

 TASK 33-41-00-962-001
 2.  Lamp Replacement (Wing Illumination Lights) (Fig. 201)___________________________________________
 A. References
 (1)  
AMM 24-22-00, Manual Control

 (2)  
SSM 33-41-10

 (3)  
WDM 33-41-11

 B. Access
 (1)  Location Zone
 200 Upper Half of the Fuselage

 C. Lamp Replacement
 S 862-002
 (1)  Open each applicable circuit breaker and attach a DO-NOT-CLOSE tag:
 (a)  On main power distribution panel, P6.
 S 962-039
 (2)  
Remove the lens and lamp retainer.

 (3)  
Carefully replace the lamp.

 S 962-041

 (4)  
Install the lamp retainer and the lens.

 S 962-040
 D. Lamp Test
 S 862-042
 (1)  Supply electrical power (AMM 24-22-00/201).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 33-41-00
 ALL  ú ú 01 Page 201 ú Jun 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

LAMP HOUSING

WING ILLUMINATION LIGHT

Wing Illumination Lights - Lamp Replacement
Figure 201

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 33-41-00
 ALL  ú ú 01 Page 202 ú Feb 10/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 747-400 MAINTENANCE MANUAL
 (2)  S 862-032Remove each DO-NOT-CLOSE tag. (a) Close each circuit breaker that was opened.
 (3)  S 712-044Set the switch to the on position. (a) Make sure the new lamp comes on correctly.
 (4)  S 862-043Set the switch to the usual position.
 (5)  S 862-045Remove electrical power if it is not necessary (AMM 24-22-00/201).

 TASK 33-41-00-822-015
 3.  Light Adjustment (Wing Illumination Lights) (Fig. 202)
________________
 A.  References
 (1)  
AMM 24-22-00/201, Manual Control

 (2)  
SSM 33-41-10

 (3)  
WDM 33-41-11

 B.  Access
 (1)  Location Zone
 200 Upper Half of the Fuselage

 C.  Procedure
 S 862-036
 (1)  Do these steps to do the adjustment:
 (a)  
Loosen the screws on the lens.

 (b)  
Remove the lens from the light assembly. 1) Let the lens assembly hang from its lanyard.

 (c)  
Loosen the four lamp adjustment screws on the lamp bracket.

 (d)  
Supply electrical power (AMM 24-22-00/201).

 (e)  
Make sure this circuit breaker is closed:

 1)  P6 Main Power Distribution Panel a) 6L33 WING ILLUM LTS

 (f)
Put the WING switch on the P5 panel to ON.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 33-41-00
 ALL  ú ú 01 Page 203 ú Feb 10/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

PRIMARY LIGHT BEAM PATTERN
____LIGHT BACK SCATTER WILL
NOTE: ILLUMINATE ENGINE INLETS.
Wing Illumination Lights Adjustment Figure 202
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 燈 LIGHTS(78)