DEGREES ` & TENTHS

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù.

 08-12-00
ú ALL ú ú 01
Page 202

 ú Nov 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 WARNING: DO NOT PRESSURIZE THE SHOCK STRUTS TO MORE THAN USUAL
_______ SERVICING PRESSURE. IF YOU DO, INJURY TO PERSONS AND DAMAGE TO SHOCK STRUTS CAN OCCUR.
 (a)  
For small adjustments, extend or retract the main and nose landing gear shock struts to usual service band limits (Ref 12-15-31, 12-15-41).

 CAUTION:_______ALL OF THE JACKS MUST HAVE PRESSURE GAGES. DO NOT USE MORE PRESSURE THAN THE LIMITS PERMIT. DAMAGE TO EQUIPMENT CAN OCCUR.

 (b)  
For large adjustments, do these steps: 1) Put the applicable jack pad adapter and jack at jacking point C (Ref 07-11-11).

 2)  Lift or lower the jack until the bubble is in the center of the vial.
 S 482-008
 (6)  Put the gage perpendicular to the airplane centerline to see if the airplane is level in the roll direction.
 NOTE: Make sure the alignment tube tips are on a flat surface of
____
 the wheel well ceiling.

 S 822-009
 (7)  Set the screw adjuster on top of the attitude gage until the pointer is on zero.
 NOTE: If the bubble is not in the center of the vial, you must lift
____ or lower the sides of the airplane as it is necessary. The bubble will move to the high side of the airplane.
 S 582-010
 (8)  Do these steps to make the airplane level about its roll axis:
 WARNING: DO NOT PRESSURIZE THE SHOCK STRUTS TO MORE THAN USUAL
_______ SERVICING PRESSURE. IF YOU DO, INJURY TO PERSONS AND DAMAGE TO SHOCK STRUTS CAN OCCUR.
 (a)  For small adjustments, extend or retract the main landing gear shock struts to usual service band limits (Ref 12-15-31).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 08-12-00
 ALL  ú ú 01 Page 203 ú Nov 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 CAUTION:_______ALL OF THE JACKS MUST HAVE PRESSURE GAGES. DO NOT USE MORE PRESSURE THAN THE LIMITS PERMIT. DAMAGE TO EQUIPMENT CAN OCCUR.
 (b)  For large adjustments, do these steps: 1) Put the applicable jack pad adapters and jacks at jacking points A and B (Ref 07-11-11).
 2)  Lift or lower the jacks until the bubble is in the center of the vial.
 S 582-007
 (9)  Do the longitudinal and lateral leveling procedures again until the bubble is in the center in each position.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 08-12-00
 ALL  ú ú 01 Page 204 ú Nov 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 WEIGHING
________
 1.  General_______
 A.  This procedure contains an outline of the procedures to weigh the airplane.
 B.  Refer to Weight and Balance Control and Loading Manual for the
 instructions to weigh the airplane.

 TASK 08-20-00-912-001
 2.  Procedures to Weigh the Airplane________________________________
 A.  Procedure
 S 912-002
 (1) There are four equally accurate procedures to weigh the airplane:
 (a)  
Landing Gear Wheels with Floor Scales

 (b)  
Main Landing Gear and Nose Gear Jack Points

 (c)  
Main Landing Gear and Forward Body Jack Points

 (d)  
Wing and Aft Body Jack Points

 S 912-003
 (2)  Determine the procedure to use based on these factors:
 (a)  
Type of equipment available
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 LEVELING AND WEIGHING(3)